Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM10000000155JO
Model Year Start: 2018 Model: Camry Prod Date Range: [06/2017 -           ]
Title: METER / GAUGE / DISPLAY: METER / GAUGE SYSTEM: Engine Oil Pressure Switch Circuit; 2018 - 2024 MY Camry [06/2017 -        ]

Engine Oil Pressure Switch Circuit

DESCRIPTION

The combination meter assembly and engine oil pressure switch assembly are connected via direct line. The combination meter assembly determines the engine oil pressure based on the engine oil pressure switch ON/OFF signal.

HINT:

  • The combination meter assembly receives engine RPM data signal from the ECM via CAN communication in order to output warnings.
  • The combination meter assembly operates the following to output oil pressure warnings:
    1. Engine oil pressure warning buzzer
    2. Engine oil pressure warning message on multi-information display

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

  • When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
  • The following troubleshooting procedure is based on the assumption that the SFI system is normal. Confirm that the SFI system is not malfunctioning before performing the following procedure.

    Click here 2018 - 2024 MY Camry [06/2017 -        ]; 2GR-FKS (ENGINE CONTROL): SFI SYSTEM: HOW TO PROCEED WITH TROUBLESHOOTING

PROCEDURE

1.

INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY

(a) Inspect the engine oil pressure switch assembly.

Click here 2018 - 2024 MY Camry [06/2017 -        ]; 2GR-FKS (LUBRICATION): OIL PRESSURE SWITCH: INSPECTION

NG

REPLACE ENGINE OIL PRESSURE SWITCH ASSEMBLY

OK

2.

CHECK HARNESS AND CONNECTOR (ENGINE OIL PRESSURE SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY)

(a) Disconnect the K21 combination meter assembly connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

C87-1 (S) - K21-9 (S)

Always

Below 1 Ω

C87-1 (S) or K21-9 (S) - Body ground

Always

10 kΩ or higher

OK

REPLACE COMBINATION METER ASSEMBLY 2018 - 2020 MY Camry [06/2017 - 10/2020]; METER / GAUGE / DISPLAY: COMBINATION METER: REMOVAL 2021 - 2024 MY Camry [10/2020 -        ]; METER / GAUGE / DISPLAY: COMBINATION METER: REMOVAL

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR