Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM100000001522Z
Model Year Start: 2018 Model: Camry Prod Date Range: [06/2017 -           ]
Title: MAINTENANCE: REAR DISC BRAKE PAD (w/ Electric Parking Brake System): REMOVAL; 2018 - 2024 MY Camry [06/2017 -        ]

REMOVAL

CAUTION / NOTICE / HINT

NOTICE:

  • Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.
  • After replacing the rear disc brake pads, the brake pedal may feel soft due to clearance between the rear disc brake pads and rear disc. Depress the brake pedal several times until the brake pedal feels firm.
  • After replacing the rear disc brake pads, always perform a road test to check the braking performance and check for vibrations.

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. PRECAUTION

Click here 2018 - 2024 MY Camry [06/2017 -        ]; PARKING BRAKE: PARKING BRAKE SYSTEM(w/ Electric Parking Brake System): PRECAUTION

2. REMOVE REAR WHEEL

Click here 2018 - 2024 MY Camry [06/2017 -        ]; MAINTENANCE: TIRE AND WHEEL: REMOVAL+

3. PERFORM REAR BRAKE PAD REPLACEMENT MODE

Click here 2018 - 2020 MY Camry [06/2017 - 10/2020]; PARKING BRAKE: ELECTRIC PARKING BRAKE SYSTEM: TEST MODE PROCEDURE 2021 - 2024 MY Camry [10/2020 -        ]; PARKING BRAKE: ELECTRIC PARKING BRAKE SYSTEM: REAR BRAKE PAD REPLACEMENT MODE

4. DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY

Click here 2018 - 2024 MY Camry [06/2017 -        ]; PARKING BRAKE: ELECTRIC PARKING BRAKE ACTUATOR: REMOVAL+

5. REMOVE REAR DISC BRAKE PAD

CAUTION:

  • Be careful not to get pinched by the rear disc brake cylinder assembly or other parts when removing the rear disc brake pads.
  • After lifting up the rear disc brake cylinder assembly, secure it in place before performing any work on it.
  • The rear disc brake cylinder assembly could fall, pinching hands or fingers and causing injury.

(a) Hold the rear No. 1 disc brake cylinder slide pin and remove the bolt.

*a

Hold

*b

Turn

(b) Pull the rear disc brake cylinder assembly upward.

(c) Remove the 2 rear disc brake pads from the rear disc brake cylinder mounting.

6. REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM KIT

(a) Remove the rear No. 2 disc brake anti-squeal shim from the rear disc brake pad (inside).

*1

Rear No. 1 Disc Brake Anti-squeal Shim

*2

Rear No. 2 Disc Brake Anti-squeal Shim

*3

Rear Disc Brake Anti-squeal Shim

*4

Rear Disc Brake Pad Wear Indicator Plate

(b) Remove the rear No. 1 disc brake anti-squeal shim from the rear disc brake pad (inside).

(c) Remove the rear disc brake anti-squeal shim from the rear disc brake pad (outside).

(d) Remove the rear disc brake pad wear indicator plate from each rear disc brake pad.