| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM1000000014Z17 |
| Model Year Start: 2018 | Model: Camry | Prod Date Range: [06/2017 - 08/2018] |
| Title: NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: Radio Receiver Power Source Circuit; 2018 MY Camry [06/2017 - 08/2018] | ||
|
Radio Receiver Power Source Circuit |
DESCRIPTION
This is the power source circuit to operate the radio and display receiver assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
|
1. |
CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY POWER SOURCE) |
(a) Disconnect the K3 and K2 radio and display receiver assembly connectors.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
K3-1 (GND1) - Body ground |
Always |
Below 1 Ω |
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
K3-4 (+B1) - K3-1 (GND1) |
Always |
11 to 14 V |
|
K3-15 (ACC1) - K3-1 (GND1) |
Engine switch on (ACC) |
11 to 14 V |
|
K2-19 (IG) - K3-1 (GND1) |
Engine switch on (IG) |
11 to 14 V |
| OK |
|
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|