Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM1000000014XZQ
Model Year Start: 2018 Model: Camry Prod Date Range: [06/2017 - 10/2020]
Title: PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: ECU Power Source Circuit; 2018 - 2020 MY Camry [06/2017 - 10/2020]

ECU Power Source Circuit

DESCRIPTION

This circuit is the power source circuit to operate the television camera controller. The television camera controller controls the panoramic view monitor system.

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuse for circuits related to this system before performing the following inspection procedure.

HINT:

If the television camera controller does not operate due to a power source problem, other system DTCs may be stored due to a CAN communication interruption.

PROCEDURE

1.

CHECK HARNESS AND CONNECTOR (TELEVISION CAMERA CONTROLLER - BODY GROUND)

(a) Disconnect the R41 television camera controller connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

R41-3 (GND1) - Body ground

Always

Below 1 Ω

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

2.

CHECK HARNESS AND CONNECTOR (TELEVISION CAMERA CONTROLLER POWER SOURCE)

(a) Disconnect the R41 television camera controller connector.

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Condition

Specified Condition

R41-2 (+B) - R41-3 (GND1)

Always

11 to 14 V

R41-1 (ACC) - R41-3 (GND1)

Engine switch on (ACC)

11 to 14 V

Engine switch off

Below 1 V

R41-6 (IG) - R41-3 (GND1)

Engine switch on (IG)

11 to 14 V

Engine switch off

Below 1 V

*a

Front view of wire harness connector

(to Television Camera Controller)

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR