Last Modified: 11-20-2023 |
6.11:8.1.0 |
Doc ID: RM1000000014XZG |
Model Year Start: 2018 |
Model: Camry |
Prod Date Range: [06/2017 - 10/2020] |
Title: PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: C1622; Open or Short Circuit in Back Camera Signal; 2018 - 2020 MY Camry [06/2017 - 10/2020] |
DTC
|
C1622
|
Open or Short Circuit in Back Camera Signal
|
DESCRIPTION
DTC C1622 is stored if the television camera controller judges as a result of its self check that the signals or signal lines between the television camera controller and the rear television camera assembly are not normal.
DTC No.
|
Detection Item
|
DTC Detection Condition
|
Trouble Area
|
DTC Output from
|
C1622
|
Open or Short Circuit in Back Camera Signal
|
Open or short in the rear television camera signal circuit
|
-
Harness or connector
-
Rear television camera assembly
-
Television camera controller
|
Television camera controller
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
-
Inspect the fuses for circuits related to this system before performing the following procedure.
-
When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.
Click here
-
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click here
PROCEDURE
1.
|
CHECK HARNESS AND CONNECTOR (TELEVISION CAMERA CONTROLLER - REAR TELEVISION CAMERA ASSEMBLY)
|
(a) Disconnect the R42 television camera controller connector.
(b) Disconnect the m1 rear television camera assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
R42-1 (CV+) - m1-3 (CV+)
|
Always
|
Below 1 Ω
|
R42-2 (CV-) - m1-2 (CV-)
|
Always
|
Below 1 Ω
|
R42-9 (CGND) - m1-5 (CGND)
|
Always
|
Below 1 Ω
|
R42-1 (CV+) or m1-3 (CV+) - Body ground
|
Always
|
10 kΩ or higher
|
R42-2 (CV-) or m1-2 (CV-) - Body ground
|
Always
|
10 kΩ or higher
|
R42-9 (CGND) or m1-5 (CGND) - Body ground
|
Always
|
10 kΩ or higher
|
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
OK
|
|
|
2.
|
CHECK HARNESS AND CONNECTOR (ACC POWER SUPPLY - GROUND)
|
(a) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
|
Condition
|
Specified Condition
|
m1-6 (CB+) - Body ground
|
Engine switch on (ACC)
|
11 to 14 V
|
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
OK
|
|
|
3.
|
CHECK TELEVISION CAMERA CONTROLLER (CV-, CGND)
|
(a) Disconnect the R42 television camera controller connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
2 (CV-) - Body ground
|
Always
|
Below 1 Ω
|
9 (CGND) - Body ground
|
Always
|
Below 1 Ω
|
|
|
*a
|
Component without harness connected
(Television Camera Controller)
|
|
|
OK
|
|
|
4.
|
CHECK REAR TELEVISION CAMERA ASSEMBLY (CV+, CGND)
|
(a) Remove the television camera controller with the connector still connected.
(b) Using an oscilloscope, check the waveform of the rear television camera assembly.
HINT:
A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the television camera controller with the connector connected.
*a
|
Component with harness connected
(Television Camera Controller)
|
*b
|
Waveform 1 (camera lens not covered, displaying an image)
|
*c
|
Waveform 2 (camera lens covered, blacking out the screen)
|
*d
|
Synchronization Signal
|
*e
|
Video Waveform
|
-
|
-
|
HINT:
-
The video waveform changes according to the image sent by the rear television camera assembly.
-
The video waveform is constantly output when the engine switch is on (ACC).
Measurement Condition
Item
|
Content
|
Terminal No. (Symbol)
|
R42-1 (CV+) - R42-9 (CGND)
|
Tool Setting
|
200 mV/DIV., 50 μsec./DIV.
|
Condition
|
Engine switch on (IG), panoramic view monitor system operating
|
OK:
Waveform is similar to that shown in the illustration.
|