INITIALIZATION

INITIALIZE PANORAMIC VIEW MONITOR SYSTEM

(a) When "!" is displayed on the radio and display receiver assembly, correct the steering angle neutral point using the following method.

(1) Fully turn the steering wheel to the left and right on level ground.

NOTICE:

Memorizing the steering angle neutral point must be carried out with the engine running. Apply the parking brake, depress the brake pedal, check that the shift lever is in P, and ensure that the vehicle is not moving.

HINT:

If the steering angle neutral point cannot be memorized by fully turning the steering wheel to the left and right, perform Steering Angle Setting in Calibration.

Click here

(b) If the RCD OFF indicator is blinking and "RCD unavailable" is displayed on the screen, perform the following procedure to set the steering angle neutral point.

(1) Fully turn the steering wheel to the right and left on flat ground.

NOTICE:

Memorizing the steering angle neutral point must be carried out with the engine started. Apply the parking brake, depress the brake pedal, check that the shift lever is in P, and ensure that the vehicle is not moving.

HINT:

If estimated course lines are not displayed on the image of the area behind the vehicle with the steering wheel fully turned to the right or left, perform "Steering Angle Setting in Calibration".

Click here