| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM1000000014VK4 |
| Model Year Start: 2018 | Model: Camry | Prod Date Range: [06/2017 - ] |
| Title: MIRROR (EXT): OUTER REAR VIEW MIRROR GLASS: REMOVAL; 2018 - 2024 MY Camry [06/2017 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. REMOVE OUTER MIRROR (for Type A)
(a) Apply protective tape to the areas shown in the illustration.
|
Protective Tape |
|
Move in this Direction |
(b) Push the upper part of the mirror surface and tilt it.
(c) Using a moulding remover, disengage the 2 claws on the lower part of the outer mirror as shown in the illustration.
NOTICE:
Do not push the outer mirror with excessive force. Doing so may cause the actuator to come off or break the mirror surface.
(d) Push the lower part of the mirror surface and tilt it.
(e) w/o Blind Spot Monitor System:
(1) Using a moulding remover, disengage the 2 claws on the upper part of the outer mirror as shown in the illustration to remove the outer mirror.
NOTICE:
Do not push the outer mirror with excessive force. Doing so may cause the actuator to come off or break the mirror surface.
|
|
Move in this Direction |
(f) w/ Blind Spot Monitor System:
(1) Using a moulding remover, disengage the 2 claws on the upper part of the outer mirror as shown in the illustration.
|
|
Move in this Direction |
NOTICE:
Do not push the outer mirror with excessive force. Doing so may cause the actuator to come off or break the mirror surface.
|
(2) Disconnect the connector. |
|
(3) Disengage the claw as shown in the illustration.
|
|
Push in this Direction |
|
(4) Disengage the clamp. |
|
(5) Disconnect the connector to remove the outer mirror.
2. REMOVE OUTER MIRROR (for Type B)
|
|
Protective Tape |
|
|
Move in this Direction |
(a) Apply protective tape to the areas shown in the illustration.
(b) Push the upper part of the mirror surface and tilt it.
(c) Using a moulding remover, disengage the 2 claws on the lower part of the outer mirror as shown in the illustration.
NOTICE:
Do not push the outer mirror with excessive force. Doing so may cause the actuator to come off or break the mirror surface.
(d) Push the lower part of the mirror surface and tilt it.
(e) Using a moulding remover, disengage the 2 claws on the upper part of the outer mirror as shown in the illustration.
NOTICE:
Do not push the outer mirror with excessive force. Doing so may cause the actuator to come off or break the mirror surface.
|
|
Move in this Direction |
|
(f) Disconnect the 2 connectors to remove the outer mirror. |
|
|
|