| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM1000000014V56 |
| Model Year Start: 2018 | Model: Camry | Prod Date Range: [06/2017 - ] |
| Title: LIGHTING (EXT): REAR COMBINATION LIGHT ASSEMBLY: DISASSEMBLY; 2018 - 2024 MY Camry [06/2017 - ] | ||
DISASSEMBLY
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. REMOVE REAR SIDE MARKER LIGHT BULB (for Bulb Type Back-up Light)
(a) Turn the rear combination light socket and wire with the rear side marker light bulb as shown in the illustration to disconnect them as a unit.
|
Remove in this Direction |
(b) Remove the rear side marker light bulb from the rear combination light socket and wire.
2. REMOVE REAR TURN SIGNAL LIGHT BULB (for Bulb Type Back-up Light)
(a) Turn the rear combination light socket and wire with the rear turn signal light bulb as shown in the illustration to disconnect them as a unit.
|
|
Remove in this Direction |
(b) Remove the rear turn signal light bulb from the rear combination light socket and wire.
3. REMOVE REAR COMBINATION LIGHT LED (for Bulb Type Back-up Light)
|
(a) Disconnect the connector. |
|
(b) Remove the screw.
(c) Turn the rear combination light LED as shown in the illustration to remove it.
|
|
Remove in this Direction |
4. REMOVE REAR COMBINATION LIGHT GASKET (for Bulb Type Back-up Light)
|
(a) Remove the rear combination light gasket. NOTICE: After the rear combination light gasket is removed, be sure to replace it with a new one. Failure to do so may cause water ingress. |
|
5. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE (for Bulb Type Back-up Light)
|
(a) Disengage the clamp to remove the rear combination light socket and wire. |
|
6. REMOVE REAR COMBINATION LIGHT CORD (for LED Type Back-up Light)
|
(a) Disengage the 2 clamps. |
|
(b) Disconnect the connector to remove the rear combination light cord.
7. REMOVE REAR COMBINATION LIGHT LENS AND BODY (for Bulb Type Back-up Light)
|
|