Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM1000000014V16
Model Year Start: 2018 Model: Camry Prod Date Range: [06/2017 - 10/2020]
Title: LIGHTING (EXT): HEADLIGHT ASSEMBLY: REMOVAL; 2018 - 2020 MY Camry [06/2017 - 10/2020]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

Front bumper assembly (w/ Panoramic view monitor system)

Front television camera view adjustment

Panoramic view monitor system

2018 - 2020 MY Camry [06/2017 - 10/2020]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: INITIALIZATION for Initialization

2018 - 2020 MY Camry [06/2017 - 10/2020]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: CALIBRATION for Calibration

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. REMOVE FRONT BUMPER ASSEMBLY

Click here 2018 - 2020 MY Camry [06/2017 - 10/2020]; EXTERIOR PANELS / TRIM: FRONT BUMPER: REMOVAL

2. REMOVE HEADLIGHT ASSEMBLY

(a) Apply protective tape around the headlight assembly as shown in the illustration.

Protective Tape

(b) Remove the bolt and 3 screws.

*a

Bolt

*b

Screw

(c) Disengage the guide to separate the headlight assembly as shown in the illustration.

Remove in this Direction

(d) for Bulb Type Turn Signal Light:

(1) Disengage the clamp.

(e) Disconnect each connector to remove the headlight assembly.