Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM1000000014UCW
Model Year Start: 2018 Model: Camry Prod Date Range: [06/2017 -           ]
Title: AXLE AND DIFFERENTIAL: REAR AXLE HUB (for 2WD with Electric Parking Brake System): REMOVAL; 2018 - 2024 MY Camry [06/2017 -        ]

REMOVAL

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. REMOVE REAR WHEEL

Click here 2018 - 2024 MY Camry [06/2017 -        ]; MAINTENANCE: TIRE AND WHEEL: REMOVAL+

2. DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY

(a) Disconnect the No. 2 parking brake wire assembly connector from the parking brake actuator assembly.

NOTICE:

  • Remove any dirt or foreign matter on and around the No. 2 parking brake wire assembly connector before performing this step.
  • Do not allow water, oil or dirt to enter the No. 2 parking brake wire assembly connector.

(b) Using a screwdriver with its tip wrapped with protective tape, disconnect the No. 2 parking brake wire assembly connector from the rear axle hub and bearing assembly.

NOTICE:

Be careful not to damage the rear axle hub and bearing assembly or connector cover.

*a

Protective Tape

3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

Click here 2018 - 2024 MY Camry [06/2017 -        ]; AXLE AND DIFFERENTIAL: REAR AXLE HUB BOLT(w/ Electric Parking Brake System): REPLACEMENT+

4. REMOVE REAR DISC

Click here 2018 - 2024 MY Camry [06/2017 -        ]; BRAKE (REAR): REAR BRAKE (w/ Electric Parking Brake System): REMOVAL+

5. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY

(a) Remove the 4 bolts, rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly from the rear axle carrier sub-assembly.