- Replacement of heated oxygen sensor
- Gas leak from exhaust system is repaired
| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM1000000014UCD |
| Model Year Start: 2018 | Model: Camry | Prod Date Range: [06/2017 - ] |
| Title: 2GR-FKS (ENGINE CONTROL): HEATED OXYGEN SENSOR: REMOVAL; 2018 - 2024 MY Camry [06/2017 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during heated oxygen sensor removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
|
Inspection after repair |
|
|
PROCEDURE
1. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH
Click here
![2018 MY Camry [06/2017 - 08/2018]; 2GR-FKS (ENGINE MECHANICAL): ENGINE ASSEMBLY: REMOVAL+](/t3Portal/stylegraphics/info.gif)
2. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH
Click here
3. REMOVE NO. 1 ENGINE UNDER COVER
Click here
4. REMOVE REAR ENGINE UNDER COVER RH
Click here
5. REMOVE HEATED OXYGEN SENSOR (for Bank 1)
|
(a) Disconnect the heated oxygen sensor connector. |
|
(b) Disengage the wire harness clamp.
|
(c) Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly. SST: 09224-00012 NOTICE: If the heated oxygen sensor has been struck or dropped, replace it. |
|
6. REMOVE FRONT FLOOR COVER LH
Click here
7. REMOVE FRONT FLOOR COVER RH
Click here
8. REMOVE BODY MOUNTING PLATE
Click here
9. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET (for Lower Side)
Click here
10. REMOVE FRONT EXHAUST PIPE ASSEMBLY
Click here
11. REMOVE HEATED OXYGEN SENSOR (for Bank 2)
|
(a) Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly. SST: 09224-00012 NOTICE: If the heated oxygen sensor has been struck or dropped, replace it. |
|
|
|