- Replacement of ignition coil assembly
- Replacement of spark plug
| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM1000000014UBX |
| Model Year Start: 2018 | Model: Camry | Prod Date Range: [06/2017 - ] |
| Title: 2GR-FKS (ENGINE CONTROL): IGNITION COIL AND SPARK PLUG: REMOVAL; 2018 - 2024 MY Camry [06/2017 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ignition coil assembly or spark plug removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
|
Inspection after repair |
|
|
PROCEDURE
1. REMOVE V-BANK COVER SUB-ASSEMBLY
Click here
![2018 MY Camry [06/2017 - 08/2018]; 2GR-FKS (ENGINE MECHANICAL): ENGINE ASSEMBLY: REMOVAL+](/t3Portal/stylegraphics/info.gif)
2. REMOVE IGNITION COIL ASSEMBLY
|
(a) Disconnect the 3 ignition coil assembly connectors. |
|
(b) Remove the 3 bolts and 3 ignition coil assemblies from the cylinder head cover sub-assembly LH.
NOTICE:
If an ignition coil assembly has been struck or dropped, replace it.
HINT:
Arrange the removed parts in the correct order.
|
(c) Disengage the 4 clamps to separate the vacuum hose from the intake air surge tank assembly. |
|
(d) Disengage the 2 wire harness clamps.
(e) Disconnect the 3 ignition coil assembly connectors.
|
(f) Remove the 3 bolts and 3 ignition coil assemblies from the cylinder head cover sub-assembly. NOTICE: If an ignition coil assembly has been struck or dropped, replace it. HINT: Arrange the removed parts in the correct order. |
|
3. REMOVE SPARK PLUG
Click here
|
|