Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM1000000014TS9
Model Year Start: 2018 Model: Camry Prod Date Range: [06/2017 - 09/2019]
Title: SUPPLEMENTAL RESTRAINT SYSTEMS: OCCUPANT CLASSIFICATION ECU: REMOVAL; 2018 - 2019 MY Camry [06/2017 - 09/2019]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during occupant detection ECU removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link
*: When performing learning using the Techstream.

Click here 2018 - 2020 MY Camry [06/2017 - 10/2020]; PARK ASSIST / MONITORING: INTELLIGENT CLEARANCE SONAR SYSTEM: CALIBRATION

  • Replacement of the occupant detection ECU
  • Removal/installation of the front passenger seat

Zero point calibration (Occupant classification system)
  • Occupant classification system
  • Passenger airbag ON/OFF indicator
  • Airbag system (Front passenger side)
  • Seat belt warning system (Front passenger)

2018 - 2024 MY Camry [06/2017 -        ]; SUPPLEMENTAL RESTRAINT SYSTEMS: OCCUPANT CLASSIFICATION SYSTEM: INITIALIZATION

Disconnect cable from negative battery terminal

Perform steering sensor zero point calibration

Lane departure alert system (w/ Steering Control)

2018 - 2020 MY Camry [03/2017 - 10/2020]; PRE-COLLISION: PRE-COLLISION SYSTEM: INITIALIZATION

Pre-collision system

Intelligent clearance sonar system*

Memorize steering angle neutral point

Parking assist monitor system

2018 - 2024 MY Camry [03/2017 -        ]; PARK ASSIST / MONITORING: PARKING ASSIST MONITOR SYSTEM: INITIALIZATION

Panoramic view monitor system

2018 - 2020 MY Camry [06/2017 - 10/2020]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: INITIALIZATION

PROCEDURE

1. REMOVE FRONT SEAT ASSEMBLY RH (for TMC Made)

Click here 2018 - 2019 MY Camry [03/2017 - 09/2019]; SEAT: FRONT SEAT ASSEMBLY (for TMC Made Manual Seat): REMOVAL

2. REMOVE FRONT SEAT ASSEMBLY RH (for TMMK Made)

HINT:

Use the same procedure as for the LH side.

for Manual Seat: Click here 2018 - 2020 MY Camry [06/2017 - 10/2020]; SEAT: FRONT SEAT ASSEMBLY (for TMMK Made Manual Seat): REMOVAL

for Power Seat: Click here 2018 - 2020 MY Camry [06/2017 - 10/2020]; SEAT: FRONT SEAT ASSEMBLY (for TMMK Made Power Seat): REMOVAL

3. REMOVE OCCUPANT DETECTION ECU (for TMC Made)

(a) Disconnect the 2 connectors.

*a

Protective Tape

(b) Using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the occupant detection ECU.

4. REMOVE OCCUPANT DETECTION ECU (for TMMK Made)

(a) Disconnect the 2 connectors.

*a

Protective Tape

(b) Using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the occupant detection ECU.