| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM1000000014TS2 |
| Model Year Start: 2018 | Model: Camry | Prod Date Range: [06/2017 - 10/2020] |
| Title: SUPPLEMENTAL RESTRAINT SYSTEMS: SEAT POSITION SENSOR (for TMMK Made): REMOVAL; 2018 - 2020 MY Camry [06/2017 - 10/2020] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during seat position airbag sensor removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
*: When performing learning using the Techstream.
Click here
|
|||
|
Disconnect cable from negative battery terminal |
Perform steering sensor zero point calibration |
Lane departure alert system (w/ Steering Control) |
|
|
Pre-collision system |
|||
|
Intelligent clearance sonar system* |
|||
|
Memorize steering angle neutral point |
Parking assist monitor system |
|
|
|
Panoramic view monitor system |
|
||
PROCEDURE
1. REMOVE FRONT SEAT ASSEMBLY LH
for Manual Seat: Click here
![2018 - 2020 MY Camry [06/2017 - 10/2020]; SEAT: FRONT SEAT ASSEMBLY (for TMMK Made Manual Seat): REMOVAL](/t3Portal/stylegraphics/info.gif)
for Power Seat: Click here
2. REMOVE SEAT POSITION AIRBAG SENSOR
|
(a) Disengage the clamp and disconnect the connector. |
|
|
(b) Using a T30 "TORX" socket wrench, remove the "TORX" bolt and seat position airbag sensor with the seat slide position sensor protector. |
|
(c) Disengage the pin to remove the seat position airbag sensor from the seat slide position sensor protector as shown in the illustration.
|
Remove in this Direction |
|
|