| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM1000000014TK5 |
| Model Year Start: 2018 | Model: Camry | Prod Date Range: [06/2017 - 10/2020] |
| Title: AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM: B15C0,B15C1; GPS Antenna Connection Malfunction(short); 2018 - 2020 MY Camry [06/2017 - 10/2020] | ||
|
DTC |
B15C0 |
GPS Antenna Connection Malfunction(short) |
|
DTC |
B15C1 |
GPS Antenna Connection Malfunction(break) |
DESCRIPTION
These DTCs are stored when a malfunction occurs in the navigation antenna assembly.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
B15C0 |
GPS Antenna Connection Malfunction(short) |
Navigation antenna malfunction |
|
|
B15C1 |
GPS Antenna Connection Malfunction(break) |
Navigation antenna power source malfunction |
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
-
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
![2018 - 2020 MY Camry [06/2017 - 10/2020]; AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM: PRECAUTION](/t3Portal/stylegraphics/info.gif)
-
When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
- A communication malfunction DTC may be stored.
- The radio and display receiver assembly may not operate normally.
-
Check that the antenna cord sub-assembly (for Navigation Antenna) is properly installed and does not have any sharp bends, pinching or loose connections before performing following procedure.
Click here
PROCEDURE
|
1. |
CHECK DTC |
(a) Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs
(b) Recheck for DTCs and check that no DTCs are output.
Body Electrical > Navigation System > Trouble Codes
OK:
No DTCs are output.
| OK |
|
USE SIMULATION METHOD TO CHECK
|
|
|
2. |
INSPECT ANTENNA CORD SUB-ASSEMBLY (for Navigation Antenna) |
(a) Remove the antenna cord sub-assembly (for navigation antenna).
Click here
|
(b) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
|
| NG |
|
REPLACE ANTENNA CORD SUB-ASSEMBLY (for Navigation Antenna)
|
|
|
3. |
INSPECT NAVIGATION ANTENNA ASSEMBLY |
(a) Remove the navigation antenna assembly.
Click here
(b) Inspect the navigation antenna assembly.
Click here
| OK |
|
| NG |
|
REPLACE NAVIGATION ANTENNA ASSEMBLY
|
|
|