Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM1000000014TJS
Model Year Start: 2018 Model: Camry Prod Date Range: [06/2017 - 10/2020]
Title: AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM: PRECAUTION; 2018 - 2020 MY Camry [06/2017 - 10/2020]

PRECAUTION

PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

  • After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal.
  • When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the terminal is reconnected.

    System Name

    See Procedure

    Lane Departure Alert System (w/ Steering Control)

    2018 MY Camry [06/2017 - 08/2018]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION 2019 MY Camry [08/2018 - 09/2019]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION 2020 MY Camry [09/2019 - 03/2020]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION 2020 MY Camry [03/2020 - 10/2020]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION

    Parking Assist Monitor System

    Intelligent Clearance Sonar System

    Pre-collision System

    Panoramic View Monitor System

IGNITION SWITCH EXPRESSIONS

(a) The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

Expression

Ignition Switch

(Position)

Engine Switch

(Condition)

Ignition Switch off

LOCK

Off (Lock)

Ignition Switch ACC

ACC

On (ACC)

Ignition Switch ON

ON

On (IG)

Engine Start

START

On (Start)

NOTICE:

  • When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
    • A communication malfunction DTC may be stored.
    • The radio and display receiver assembly may not operate normally.
  • When replacing the DCM (telematics transceiver), be sure to replace it with a new one (w/ Manual (SOS) Switch).

PRECAUTION FOR AUDIO AND VISUAL SYSTEM

(a) If any of the following parts are replaced, refer to Initialization in Repair Instruction.

Click here 2018 MY Camry [06/2017 - 08/2018]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION 2019 MY Camry [08/2018 - 09/2019]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION 2020 MY Camry [09/2019 - 03/2020]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION 2020 MY Camry [03/2020 - 10/2020]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION

  • Radio and display receiver assembly*1
  • DCM (telematics transceiver)*2
  • *1: After replacing the radio and display receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, SiriusXM radio ID registration is necessary (w/ SXM Function).

    *2: w/ Manual (SOS) Switch