Open or short in stop light switch circuit
|
Cruise Control Malfunction Visit Your Dealer
|
Illuminates
|
Sounds
|
Dynamic radar cruise control system is turned off and back on again using the cruise control main switch.
|
Malfunction in SFI system
|
-
|
Illuminates
|
-
|
Dynamic radar cruise control system is turned off and back on again using the cruise control main switch.
|
If either of the following conditions occurs, the ECM cancels control of vehicle speed by the dynamic radar cruise control system (stored vehicle speed is maintained):
-
Vehicle speed is less than approximately 40 km/h (25 mph) while driving with the dynamic radar cruise control system controlling vehicle speed
-
A preceding vehicle is not detected when follow-up control is being performed at a vehicle speed of approximately 40 km/h (25 mph) or less*
|
-
|
Does not illuminate
|
Sounds twice
|
+RES switch is pushed.
|
-
Malfunction in the millimeter wave radar sensor assembly
-
Beam axis of millimeter wave radar sensor assembly misaligned
-
Problem with stop light switch input circuit
-
Problem with cruise control main switch cancel circuit
|
Cruise Control Malfunction Visit Your Dealer
|
Illuminates
|
Sounds
|
Ignition switch is turned off and back to ON again.
|
If the following condition occurs, the ECM cancels control of vehicle speed by the dynamic radar cruise control system (stored vehicle speed is maintained):
-
Millimeter wave radar sensor assembly becomes dirty
|
Radar Cruise Control Unavailable Clean Sensor
|
Illuminates
|
Sounds
|
The condition returns to normal (the resume function can be operated after fail-safe is deactivated).
|
If any of the conditions listed below occurs, the ECM cancels control of vehicle speed by the dynamic radar cruise control system (stored vehicle speed is maintained):
-
Millimeter wave radar sensor assembly sensitivity reduced because of bad weather such as rain, fog, snow, or sandstorm
-
Brake control by the dynamic radar cruise control system is temporarily unavailable
-
The beam axis of the millimeter wave radar sensor assembly is being aligned
-
The forward recognition camera is temporarily unavailable
-
A system check is being performed after the engine has started
|
Radar Cruise Control Unavailable
|
Illuminates
|
Sounds
|
The conditions return to normal (the resume function can be operated after fail-safe is deactivated).
|
-
Vehicle stability control system operates while driving with cruise control system controlling vehicle speed
-
TRAC system operates for a certain period of time while driving with cruise control system controlling vehicle speed.
-
TRAC is turned off
-
VSC is turned off
-
Drive start control is performed
-
Intelligent clearance sonar detects an object (w/ Intelligent Clearance Sonar System)*
-
Parking brake is applied (w/o Electric Parking Brake System)*
-
Electric parking brake is applied (w/ Electric Parking Brake System)*
|
-
|
Does not illuminate
|
-
|
+RES switch is pushed.
|
If any of the following conditions occur while the vehicle stopped, the ECM cancels control of vehicle speed by the dynamic radar cruise control system*:
-
Open or short in stop light switch circuit
-
Malfunction in the millimeter wave radar sensor assembly
-
Beam axis of millimeter wave radar sensor assembly misaligned
-
Problem with stop light switch input circuit
-
Problem with cruise control main switch cancel circuit
-
Millimeter wave radar sensor assembly sensitivity reduced because of bad weather such as rain, fog, snow, or sandstorm
-
Millimeter wave radar sensor assembly becomes dirty
-
Brake control by the dynamic radar cruise control system is temporarily unavailable
-
The beam axis of the millimeter wave radar sensor assembly is being aligned
-
The forward recognition camera is temporarily unavailable
-
A system check is being performed after the engine has started
|
Cruise Control Fault Press Brake to Deactivate Visit Your Dealer
|
Illuminates
|
4 beeps are heard
|
The conditions return to normal (the resume function can be operated after fail-safe is deactivated).
|
If any of the following conditions occur while the vehicle is stopped, the ECM cancels control of vehicle speed by the dynamic radar cruise control system*:
-
The driver seat belt is unfastened
-
The driver door is opened
-
The vehicle is parked for a long period of time
-
The vehicle is stopped on a steep hill
-
A preceding vehicle is not detected
|
Radar Cruise Control Unavailable Press Brake to Resume Driving
|
Does not illuminate
|
-
|
The conditions return to normal (the resume function can be operated after fail-safe is deactivated).
|