| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM1000000014T0N |
| Model Year Start: 2018 | Model: Camry | Prod Date Range: [06/2017 - 10/2020] |
| Title: HEATING / AIR CONDITIONING: COMPRESSOR (for 2GR-FKS): REMOVAL; 2018 - 2020 MY Camry [06/2017 - 10/2020] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during compressor assembly with magnetic clutch removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
Front bumper assembly (w/ Panoramic view monitor system) |
Front television camera view adjustment |
Panoramic view monitor system |
|
PROCEDURE
1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
for HFC-134a (R134a):
Click here
![2018 - 2020 MY Camry [06/2017 - 10/2020]; HEATING / AIR CONDITIONING: REFRIGERANT (for HFC-134a(R134a)): REPLACEMENT+](/t3Portal/stylegraphics/info.gif)
for HFO-1234yf (R1234yf):
Click here
2. REMOVE V-RIBBED BELT
Click here
3. REMOVE RADIATOR ASSEMBLY
Click here
4. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE SUB-ASSEMBLY
|
(a) Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose sub-assembly from the compressor assembly with magnetic clutch. |
|
(b) Remove the O-ring from the No. 1 cooler refrigerant discharge hose sub-assembly.
NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
5. DISCONNECT SUCTION HOSE SUB-ASSEMBLY
|
(a) Remove the bolt and disconnect the suction hose sub-assembly from the compressor assembly with magnetic clutch. |
|
(b) Remove the O-ring from the suction hose sub-assembly.
NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
6. REMOVE COMPRESSOR ASSEMBLY WITH MAGNETIC CLUTCH
|
(a) Disconnect each connector. |
|
(b) Disengage each clamp.
(c) for Type A:
(1) Remove the 2 bolts and 2 nuts, and separate the bracket.
|
*a |
Bracket |
|
Bolt |
|
Nut |
|
(2) Using an E8 "TORX" socket wrench, remove the 2 stud bolts. |
|
(d) for Type B:
|
(1) Remove the 4 bolts and separate the bracket. |
|
(e) Remove the compressor assembly with magnetic clutch.
|
|