| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM1000000014501 |
| Model Year Start: 2018 | Model: Camry | Prod Date Range: [03/2017 - 10/2020] |
| Title: CRUISE CONTROL: LANE DEPARTURE ALERT SYSTEM (w/ Steering Control): C1AA0; Front Camera Module Circuit; 2018 - 2020 MY Camry [03/2017 - 10/2020] | ||
|
DTC |
C1AA0 |
Front Camera Module Circuit |
DESCRIPTION
When an internal malfunction is detected in the forward recognition camera, DTC C1AA0 is stored.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
C1AA0 |
Front Camera Module Circuit |
After the ignition switch is turned to ON for 3 seconds or more, the forward recognition camera detects an internal malfunction. |
Forward recognition camera |
CAUTION / NOTICE / HINT
NOTICE:
- When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.
-
If the forward recognition camera has been replaced with a new one, be sure to perform forward recognition camera adjustment.
Click here
![2018 - 2020 MY Camry [03/2017 - 10/2020]; CRUISE CONTROL: FRONT CAMERA: ADJUSTMENT (SEQUENTIAL RECOGNITION)](/t3Portal/stylegraphics/info.gif)
PROCEDURE
|
1. |
CHECK FOR DTCs (LANE DEPARTURE ALERT SYSTEM) |
(a) Clear the DTCs.
Chassis > LKA/LDA > Clear DTCs
(b) Perform the following procedure.
HINT:
If the following procedure is not performed, the previously output DTC cannot be detected.
- Turn the ignition switch to ON and wait 3 seconds or more.
(c) Check for DTCs.
Chassis > LKA/LDA > Trouble Codes
|
Result |
Proceed to |
|---|---|
|
DTC C1AA0 is not output |
A |
|
DTC C1AA0 is output |
B |
| A |
|
USE SIMULATION METHOD TO CHECK
|
| B |
|
|
|