Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM10000000134QE
Model Year Start: 2018 Model: Camry Prod Date Range: [03/2017 -           ]
Title: DOOR LOCK: WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Smart Key System): REGISTRATION; 2018 - 2024 MY Camry [03/2017 -        ]

REGISTRATION

CAUTION / NOTICE / HINT

HINT:

  • Register a new recognition code when replacing a door control transmitter module set sub-assembly or the door control and tire pressure monitoring system receiver assembly.
  • Add mode is used to retain the codes that have already been registered while registering a new recognition code. This mode is used when adding a door control transmitter module set sub-assembly.
  • Rewrite mode is used to clear all the previously registered codes and register only new recognition codes. This mode is used when replacing a door control transmitter module set sub-assembly or the door control and tire pressure monitoring system receiver assembly with a new one.
  • Confirmation mode is used to confirm how many recognition codes have already been registered before additional registration of a recognition code.
  • Prohibition mode is used to clear all the registered codes and cancel the wireless door lock function. Use this mode when a door control transmitter module set sub-assembly is lost.
  • All of the steps in the following registration procedure must be performed in sequential order continuously.

PROCEDURE

1. REGISTRATION OF RECOGNITION CODE (USING TECHSTREAM)

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Main Body / Utility / Wireless Code Registration.

Body Electrical > Main Body > Utility

Tester Display

Wireless Code Registration

(e) Select either add or rewrite mode according to the Techstream display.

(f) The number of registered codes is indicated.

(g) Registration of the door control transmitter module set sub-assembly

(1) If either add mode or rewrite mode has been selected, press the lock and unlock switches on the door control transmitter module set sub-assembly simultaneously.

(2) Within 3 seconds of releasing the lock and unlock switches, press either of the switches on the door control transmitter module set sub-assembly.

NOTICE:

  • Do not press the lock and unlock switches simultaneously for more than 1.5 seconds.
  • Perform this operation within 1 meter of the driver seat to register the door control transmitter module set sub-assembly.
  • Do not push other door control transmitter module set sub-assembly switches during the door control transmitter module set sub-assembly registration process.

(3) If continuing registration, the next recognition code must be registered in the door control and tire pressure monitoring system receiver assembly within 40 seconds.

HINT:

Up to 6 recognition codes can be registered.

(h) Completing the registration mode.

(1) Registration mode will end when any of the following occurs:

  • 40 seconds or more have elapsed after a code is registered.
  • The Techstream is used to finish registration.
  • The Techstream is disconnected.
  • The ignition switch is turned off.

(i) Perform the following after registration is completed.

(1) Perform the wireless door lock control operation check.

Click here 2018 MY Camry [03/2017 - 06/2017]; DOOR LOCK: WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Smart Key System): OPERATION CHECK 2018 - 2024 MY Camry [06/2017 -        ]; DOOR LOCK: WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Smart Key System): OPERATION CHECK

HINT:

If the wireless door lock control does not operate, perform the registration procedure again.