Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM1000000012W1R
Model Year Start: 2018 Model: Camry Prod Date Range: [03/2017 - 06/2017]
Title: PRE-COLLISION: PRE-COLLISION SYSTEM: C1A46; Yaw Rate Sensor; 2018 MY Camry [03/2017 - 06/2017]

DTC

C1A46

Yaw Rate Sensor

DESCRIPTION

If the millimeter wave radar sensor assembly receives a yaw rate sensor malfunction signal from the yaw rate sensor (airbag sensor assembly) or yaw rate sensor zero point malfunction signal from the skid control ECU (brake actuator assembly), DTC C1A46 will be stored.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1A46

Yaw Rate Sensor
  • While the vehicle is being driven at a speed of 5 km/h (4 mph) or more, the millimeter wave radar sensor assembly receives a yaw rate sensor malfunction signal from the yaw rate sensor for approximately 10 seconds.
  • While the vehicle is being driven at a speed of 5 km/h (4 mph) or more, the millimeter wave radar sensor assembly receives a yaw rate sensor zero point malfunction signal from the skid control ECU (brake actuator assembly) for approximately 10 seconds.
  • Vehicle stability control system
  • Millimeter wave radar sensor assembly

CAUTION / NOTICE / HINT

NOTICE:

  • When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle. As a result, a DTC may be stored.
  • If the millimeter wave radar sensor assembly has been replaced, be sure to perform millimeter wave radar sensor assembly adjustment.

    Click here 2018 MY Camry [03/2017 - 06/2017]; CRUISE CONTROL: MILLIMETER WAVE RADAR SENSOR: ADJUSTMENT

  • The pre-collision system uses the CAN communication system. First, confirm that there are no malfunctions in the CAN communication system. Refer to How to Proceed with Troubleshooting.

    Click here 2018 - 2024 MY Camry [03/2017 -        ]; NETWORKING: CAN COMMUNICATION SYSTEM: HOW TO PROCEED WITH TROUBLESHOOTING

PROCEDURE

1.

CHECK FOR DTCs (VEHICLE STABILITY CONTROL SYSTEM)

HINT:

Pre-collision system DTC C1A46 may be stored due to a malfunction in the vehicle stability control system. Therefore, it is necessary to check for and troubleshoot vehicle stability control system DTCs first.

(a) Check for DTCs.

Chassis > ABS/VSC/TRAC > Trouble Codes

Result

Proceed to

Vehicle stability control system DTCs are not output

A

Vehicle stability control system DTCs are output

B
B

GO TO VEHICLE STABILITY CONTROL SYSTEM

A

2.

CHECK FOR DTCs (PRE-COLLISION SYSTEM)

(a) Clear the DTCs.

Body Electrical > Pre-Collision 2 > Clear DTCs

(b) Perform the following procedure.

HINT:

If the following procedure is not performed, the previously output DTC cannot be detected.

  1. Drive the vehicle at a speed of 5 km/h (4 mph) or more for 10 seconds or more.

(c) Check for DTCs.

Body Electrical > Pre-Collision 2 > Trouble Codes

Result

Proceed to

DTC C1A46 is not output

A

DTC C1A46 is output

B
A

USE SIMULATION METHOD TO CHECK

B

REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY