Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM1000000012VPR
Model Year Start: 2018 Model: Camry Prod Date Range: [03/2017 -           ]
Title: THEFT DETERRENT / KEYLESS ENTRY: IMMOBILISER SYSTEM (w/o Smart Key System): B2796,B2798; No Communication in Immobiliser System; 2018 - 2024 MY Camry [03/2017 -        ]

DTC

B2796

No Communication in Immobiliser System

DTC

B2798

Communication Malfunction No. 2

DESCRIPTION

This DTC is stored when a door control transmitter assembly is inserted into the ignition key cylinder but no communication occurs between the door control transmitter assembly and transponder key ECU assembly.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Note

B2796

No Communication in Immobiliser System

The key ID code cannot be transmitted to the transponder key ECU assembly (1 trip detection logic*).

  • Door control transmitter assembly
  • Wire harness or connector

DTC Output Confirmation Operation:

  • Insert the door control transmitter assembly into the ignition key cylinder.

B2798

Communication Malfunction No. 2

Key ID code identification cannot be completed within the specified time (1 trip detection logic*).

  • Door control transmitter assembly
  • Wire harness or connector

DTC Output Confirmation Operation:

  • Insert the door control transmitter assembly into the ignition key cylinder.
  • *: Only output while a malfunction is present.

Vehicle Condition and Fail-safe Operation when Malfunction Detected

Vehicle Condition when Malfunction Detected

Fail-safe Operation when Malfunction Detected

Engine cannot be started

-

Related Data List and Active Test

DTC No.

Data List and Active Test

B2796

-

B2798

-

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

  • If the door control transmitter assembly is replaced, refer to Registration.

    Click here 2018 - 2019 MY Camry [03/2017 - 09/2019]; THEFT DETERRENT / KEYLESS ENTRY: IMMOBILISER SYSTEM (w/o Smart Key System): REGISTRATION 2020 - 2024 MY Camry [09/2019 -        ]; THEFT DETERRENT / KEYLESS ENTRY: IMMOBILISER SYSTEM (w/o Smart Key System): REGISTRATION

  • After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".

PROCEDURE

1.

CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU ASSEMBLY - TRANSPONDER KEY COIL)

(a) Disconnect the K60 transponder key ECU assembly connector.

(b) Disconnect the K61 transponder key coil connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

K60-2 (ANT1) - K61-1 (ANT1)

Always

Below 1 Ω

K60-3 (ANT2) - K61-5 (ANT2)

Always

Below 1 Ω

K60-2 (ANT1) or K61-1 (ANT1) - Other terminals and body ground

Always

10 kΩ or higher

K60-3 (ANT2) or K61-5 (ANT2) - Other terminals and body ground

Always

10 kΩ or higher

OK

REPLACE DOOR CONTROL TRANSMITTER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR