| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM1000000012VFB |
| Model Year Start: 2018 | Model: Camry | Prod Date Range: [03/2017 - 06/2017] |
| Title: PARK ASSIST / MONITORING: BLIND SPOT MONITOR SYSTEM: C1AB4; Open in Outer Mirror Indicator(Master); 2018 MY Camry [03/2017 - 06/2017] | ||
|
DTC |
C1AB4 |
Open in Outer Mirror Indicator(Master) |
DESCRIPTION
This DTC is stored when the blind spot monitor sensor RH detects an open in the outer rear view mirror indicator RH.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
C1AB4 |
Open in Outer Mirror Indicator(Master) |
Both of the following conditions are met:
|
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
When checking for DTCs, make sure that the blind spot monitor system is turned on.
PROCEDURE
|
1. |
CHECK DTC |
(a) Turn the ignition switch off.
(b) Turn the ignition switch to ON.
(c) Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Blind Spot Monitor Master > Trouble Codes
OK:
No DTCs are output.
| OK |
|
|
|
2. |
CHECK HARNESS AND CONNECTOR (OUTER REAR VIEW MIRROR ASSEMBLY WITH COVER RH - BLIND SPOT MONITOR SENSOR RH AND BODY GROUND) |
(a) Disconnect the W5 blind spot monitor sensor RH connector.
(b) Disconnect the N18 outer rear view mirror assembly with cover RH connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
W5-4 (OMIR) - N18-1 (BSR+) |
Always |
Below 1 Ω |
|
N18-4 (E) - Body ground |
Always |
Below 1 Ω |
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
3. |
INSPECT OUTER REAR VIEW MIRROR ASSEMBLY WITH COVER RH |
(a) Disconnect the IND1 outer mirror RH connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
N18-1 (BSR+) - IND1-2 (+) |
Always |
Below 1 Ω |
|
N18-4 (E) - IND1-1 (-) |
Always |
Below 1 Ω |
| NG |
|
|
|
4. |
INSPECT OUTER MIRROR RH |
(a) Remove the outer mirror RH.
Click here
![2018 MY Camry [03/2017 - 06/2017]; MIRROR (EXT): OUTER REAR VIEW MIRROR GLASS: REMOVAL](/t3Portal/stylegraphics/info.gif)
(b) Inspect the outer rear view mirror indicator RH on the outer mirror RH.
Click here
| OK |
|
| NG |
|
|
|