| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM1000000012VF4 |
| Model Year Start: 2018 | Model: Camry | Prod Date Range: [03/2017 - 06/2017] |
| Title: PARK ASSIST / MONITORING: BLIND SPOT MONITOR SYSTEM: C1A45; Vehicle Speed Sensor; 2018 MY Camry [03/2017 - 06/2017] | ||
|
DTC |
C1A45 |
Vehicle Speed Sensor |
DESCRIPTION
The blind spot monitor sensor receives vehicle speed signals from the skid control ECU via CAN communication.
Blind Spot Monitor Master
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
C1A45 |
Vehicle Speed Sensor |
A fail flag is transmitted from the skid control ECU |
|
Blind Spot Monitor Slave
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
C1A45 |
Vehicle Speed Sensor |
A fail flag is transmitted from the skid control ECU |
|
CAUTION / NOTICE / HINT
NOTICE:
When checking for DTCs, make sure that the blind spot monitor system is turned on.
PROCEDURE
|
1. |
CHECK OTHER DTC OUTPUT (VEHICLE STABILITY CONTROL SYSTEM) |
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Turn the Techstream on.
(e) Read the DTCs following the prompts on the Techstream. Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.
Chassis > ABS/VSC/TRAC > Trouble Codes
OK:
Vehicle stability control system DTCs are not output.
| NG |
|
|
|
2. |
CHECK DTC |
(a) Turn the ignition switch off.
(b) Turn the ignition switch to ON.
(c) Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Blind Spot Monitor Master > Trouble Codes
Body Electrical > Blind Spot Monitor Slave > Trouble Codes
|
Result |
Proceed to |
|---|---|
|
No DTCs are output |
A |
|
DTC C1A45 is output ("Blind Spot Monitor Master") |
B |
|
DTC C1A45 is output ("Blind Spot Monitor Slave") |
C |
| A |
|
| B |
|
| C |
|
|
|