REMOVAL

PROCEDURE

1. REMOVE FRONT WHEEL LH

Click here

2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

HINT:

Use the same procedure as for the RH side.

Click here

3. REMOVE FRONT FENDER LINER LH

HINT:

Use the same procedure as for the RH side.

Click here

4. REMOVE COOL AIR INTAKE DUCT SEAL

Click here

5. REMOVE HOOD LOCK ASSEMBLY

(a) Disconnect the connector.

(b) Using a screwdriver with its tip wrapped with protective tape, remove the hood lock nut cap.

*a Protective Tape

(c) Remove the 2 bolts and hood lock bolt.

*1 Hood Lock Bolt

(d) Disconnect the hood lock control cable assembly to remove the hood lock assembly.

6. REMOVE FRONT DOOR SCUFF PLATE LH

Click here

7. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH

Click here

8. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Click here

9. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Click here

10. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

(a) for Type A:

(1) Disconnect the hood lock control cable assembly to remove the hood lock control lever sub-assembly. HINT: When changing the hood lock control lever sub-assembly from type A to type B, the hood lock control cable assembly must also be changed to type B.

(b) for Type B:

(1) Disconnect the hood lock control cable assembly to remove the hood lock control lever sub-assembly. HINT: When changing the hood lock control lever sub-assembly from type B to type A, the hood lock control cable assembly must also be changed to type A.

11. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY

(a) Disengage the clamp.

(b) Using a screwdriver, disengage the 4 clamps and grommet as shown in the illustration.

HINT:

Tape the screwdriver tip before use.

(c) Pull the hood lock control cable assembly from the engine compartment to remove it.