| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM1000000012UQ1 |
| Model Year Start: 2018 | Model: Camry | Prod Date Range: [03/2017 - 06/2017] |
| Title: METER / GAUGE / DISPLAY: COMBINATION METER: REMOVAL; 2018 MY Camry [03/2017 - 06/2017] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during combination meter assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
Disconnect cable from negative battery terminal |
Perform steering sensor zero point calibration |
Lane departure alert system(w/ Steering Control) |
|
|
Pre-collision system |
|||
|
Memorize steering angle neutral point |
Parking assist monitor system |
|
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click here
![2018 MY Camry [03/2017 - 06/2017]; INTRODUCTION: REPAIR INSTRUCTION: PRECAUTION](/t3Portal/stylegraphics/info.gif)
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click here
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
3. REMOVE NO. 1 METER HOOD CLUSTER
Click here
4. REMOVE NO. 2 METER HOOD CLUSTER
Click here
5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
(a) Operate the tilt and telescopic lever to fully extend and lower the steering column assembly.
(b) Apply protective tape to the area shown in the illustration.
|
Protective Tape |
(c) Apply protective tape to the area shown in the illustration.
|
|
Protective Tape |
(d) Disengage the 2 claws and 4 clips to separate the instrument cluster finish panel assembly.
|
Remove in this Direction |
|
(e) Remove the 2 clips. |
|
(f) Disengage the 2 clips as shown in the illustration.
|
Place Hand Here |
|
|
Remove in this Direction |
(g) Disengage the 2 clips as shown in the illustration.
|
|
Place Hand Here |
|
|
Remove in this Direction |
(h) Disengage the 2 guides as shown in the illustration.
|
|
Remove in this Direction |
(i) Disconnect the connector to remove the instrument cluster finish panel assembly.
6. REMOVE COMBINATION METER ASSEMBLY
|
(a) Remove the 3 screws. |
|
(b) Disengage the 2 clips as shown in the illustration.
|
|
Remove in this Direction |
(c) Disengage the clamp.
(d) Disconnect each connector to remove the combination meter assembly.
|
|