Last Modified: 11-20-2023 |
6.11:8.1.0 |
Doc ID: RM1000000012UOO |
Model Year Start: 2018 |
Model: Camry |
Prod Date Range: [03/2017 -
] |
Title: METER / GAUGE / DISPLAY: METER / GAUGE SYSTEM: Steering Pad Switch Circuit; 2018 - 2024 MY Camry [03/2017 - ] |
Steering Pad Switch Circuit
|
DESCRIPTION
The combination meter assembly and steering pad switch assembly are connected via direct line. The multi-information display in the combination meter assembly are operated using the switches of the steering pad switch assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
PROCEDURE
1.
|
INSPECT STEERING PAD SWITCH ASSEMBLY
|
(a) Remove the steering pad switch assembly.
Click here
(b) Inspect the steering pad switch assembly.
Click here
OK
|
|
|
2.
|
INSPECT SPIRAL CABLE SUB-ASSEMBLY
|
(a) Remove the spiral cable sub-assembly.
Click here
(b) Inspect the spiral cable sub-assembly.
Click here
OK
|
|
|
3.
|
CHECK HARNESS AND CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY - COMBINATION METER ASSEMBLY)
|
(a) Disconnect the K21 combination meter assembly connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
K22-10 (+DP2) - K21-28 (MSM+)
|
Always
|
Below 1 Ω
|
K22-11 (+DP) - K21-29 (MSTI)
|
Always
|
Below 1 Ω
|
K22-10 (+DP2) or K21-28 (MSM+) - Body ground
|
Always
|
10 kΩ or higher
|
K22-11 (+DP) or K21-29 (MSTI) - Body ground
|
Always
|
10 kΩ or higher
|
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
|