METER / GAUGE / DISPLAY: METER / GAUGE SYSTEM: Meter Illumination does not Dim at Night; 2018 - 2024 MY Camry [03/2017

Last Modified: 11-20-2023	6.11:8.1.0	Doc ID: RM1000000012UO6
Model Year Start: 2018	Model: Camry	Prod Date Range: [03/2017 - ]
Title: METER / GAUGE / DISPLAY: METER / GAUGE SYSTEM: Meter Illumination does not Dim at Night; 2018 - 2024 MY Camry [03/2017 - ]

Meter Illumination does not Dim at Night

DESCRIPTION

In this circuit, the combination meter assembly receives auto dimmer signals from the main body ECU (multiplex network body ECU) via CAN communication. When the combination meter assembly receives an auto dimmer signal, it dims the meter illumination (warning and indicator lights).

The main body ECU (multiplex network body ECU) determines whether it is daytime or nighttime based on the waveform transmitted from the automatic light control sensor. If the main body ECU (multiplex network body ECU) determines that it is nighttime and the headlight dimmer switch assembly is in the tail, head, or AUTO position, the ECU sends an auto dimmer signal to the combination meter assembly.

According to this signal, the combination meter assembly dims the meter illumination.

HINT:

When the meter illumination does not dim at night, there may be a malfunction in the automatic light control sensor, main body ECU (multiplex network body ECU), CAN communication system, wire harness, connector, or combination meter assembly.

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
Before replacing the main body ECU (multiplex network body ECU), refer to Registration.*
Click here
- *: w/ Smart Key System

HINT:

The automatic light control sensor sensitivity can be customized.
Click here
Setting the meter illumination level to maximum brightness prevents the meter illumination from dimming when the headlight dimmer switch assembly is changed to the tail, head, or AUTO position at night. Therefore, check the meter illumination setting before proceeding to the following steps.

PROCEDURE

1.	CHECK CAN COMMUNICATION SYSTEM

(a) Check if CAN communication DTCs are output.

Click here

Result	Proceed to
DTCs are not output	A
DTCs are output	B

GO TO CAN COMMUNICATION SYSTEM

2.	CHECK FOR DTC (LIGHTING SYSTEM)

(a) Check if lighting system DTCs are output.

Body Electrical > Main Body > Trouble Codes

Result	Proceed to
DTC B1244 is not output	A
DTC B1244 is output	B

GO TO DTC B1244

3.	REPLACE COMBINATION METER ASSEMBLY

(a) Replace the combination meter assembly with a new one.

Click here

OK:

The operation of the combination meter assembly returns to normal.

END (COMBINATION METER ASSEMBLY WAS DEFECTIVE)

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)