Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM1000000012UAQ
Model Year Start: 2018 Model: Camry Prod Date Range: [03/2017 - 06/2017]
Title: STEERING COLUMN: STEERING PAD SWITCH: REMOVAL; 2018 MY Camry [03/2017 - 06/2017]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during steering pad switch assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

Disconnect cable from negative battery terminal

Perform steering sensor zero point calibration

Lane Departure Alert System (w/ Steering Control)

2018 - 2020 MY Camry [03/2017 - 10/2020]; PRE-COLLISION: PRE-COLLISION SYSTEM: INITIALIZATION

Pre-collision system

Memorize steering angle neutral point

Parking Assist Monitor System

2018 - 2024 MY Camry [03/2017 -        ]; PARK ASSIST / MONITORING: PARKING ASSIST MONITOR SYSTEM: INITIALIZATION

PROCEDURE

1. REMOVE HORN BUTTON ASSEMBLY

Click here 2018 MY Camry [03/2017 - 06/2017]; SUPPLEMENTAL RESTRAINT SYSTEMS: STEERING PAD: REMOVAL

2. REMOVE STEERING PAD SWITCH ASSEMBLY

(a) Disconnect the steering pad switch connector from the spiral cable with sensor sub-assembly.

(b) Remove the 2 screws.

(c) Disengage the 4 claws and 3 pins to remove the steering pad switch assembly.