Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM1000000012TWD
Model Year Start: 2018 Model: Camry Prod Date Range: [03/2017 - 06/2017]
Title: PARKING BRAKE: PARKING BRAKE CABLE (for Rear Side): REMOVAL; 2018 MY Camry [03/2017 - 06/2017]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during No. 3 parking brake cable assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

Disconnect cable from negative battery terminal

Perform steering sensor zero point calibration

Lane departure alert system (w/ Steering Control)

2018 - 2020 MY Camry [03/2017 - 10/2020]; PRE-COLLISION: PRE-COLLISION SYSTEM: INITIALIZATION

Pre-collision system

Memorize steering angle neutral point

Parking assist monitor system

2018 - 2024 MY Camry [03/2017 -        ]; PARK ASSIST / MONITORING: PARKING ASSIST MONITOR SYSTEM: INITIALIZATION

Removal/installation of the front passenger seat

Zero point calibration (Occupant classification system)
  • Occupant classification system
  • Passenger airbag ON/OFF indicator
  • Airbag system (Front passenger side)
  • Seat belt warning system (Front passenger)

2018 MY Camry [03/2017 - 06/2017]; SUPPLEMENTAL RESTRAINT SYSTEMS: OCCUPANT CLASSIFICATION SYSTEM: INITIALIZATION

  • Replacement of air fuel ratio sensor
  • Gas leak from exhaust system is repaired

Inspection after repair
  • Poor idle, etc.
  • Engine start function, etc.

2018 - 2019 MY Camry [03/2017 - 09/2019]; A25A-FKS (ENGINE CONTROL): SFI SYSTEM: INITIALIZATION

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.

HINT:

Use the same procedure for the No. 2 parking brake cable assembly and No. 3 parking brake cable assembly.

PROCEDURE

1. REMOVE FRONT SEAT ASSEMBLY LH

Click here 2018 - 2019 MY Camry [03/2017 - 09/2019]; SEAT: FRONT SEAT ASSEMBLY (for TMC Made Power Seat): REMOVAL

2. REMOVE FRONT SEAT ASSEMBLY RH

Click here 2018 - 2019 MY Camry [03/2017 - 09/2019]; SEAT: FRONT SEAT ASSEMBLY (for TMC Made Manual Seat): REMOVAL

3. REMOVE CONSOLE BOX ASSEMBLY

Click here 2018 MY Camry [03/2017 - 06/2017]; INTERIOR PANELS / TRIM: FRONT CONSOLE BOX: REMOVAL

4. DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY

Click here 2018 MY Camry [03/2017 - 06/2017]; SEAT: REAR SEAT ASSEMBLY (for Fold Down Seat Type): REMOVAL+

5. REMOVE REAR SEAT CUSHION ASSEMBLY

Click here 2018 MY Camry [03/2017 - 06/2017]; SEAT: REAR SEAT ASSEMBLY (for Fold Down Seat Type): REMOVAL+

6. REMOVE REAR SEAT CUSHION LOCK HOOK

Click here 2018 MY Camry [03/2017 - 06/2017]; SEAT: REAR SEAT ASSEMBLY (for Fold Down Seat Type): REMOVAL+

7. REMOVE FRONT DOOR SCUFF PLATE LH

Click here 2018 MY Camry [03/2017 - 06/2017]; INTERIOR PANELS / TRIM: ROOF HEADLINING: REMOVAL+

8. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH

Click here 2018 MY Camry [03/2017 - 06/2017]; INTERIOR PANELS / TRIM: ROOF HEADLINING: REMOVAL+

9. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Click here 2018 MY Camry [03/2017 - 06/2017]; INTERIOR PANELS / TRIM: INSTRUMENT PANEL SAFETY PAD: REMOVAL+

10. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH

Click here 2018 MY Camry [03/2017 - 06/2017]; SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: REMOVAL+

11. REMOVE REAR DOOR SCUFF PLATE LH

Click here 2018 MY Camry [03/2017 - 06/2017]; INTERIOR PANELS / TRIM: ROOF HEADLINING: REMOVAL+

12. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH

Click here 2018 MY Camry [03/2017 - 06/2017]; SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: REMOVAL+

13. REMOVE LOWER CENTER PILLAR GARNISH LH

Click here 2018 MY Camry [03/2017 - 06/2017]; INTERIOR PANELS / TRIM: ROOF HEADLINING: REMOVAL+

14. REMOVE FRONT DOOR SCUFF PLATE RH

HINT:

Use the same procedure as for the LH side.

15. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

16. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Click here 2018 MY Camry [03/2017 - 06/2017]; INTERIOR PANELS / TRIM: INSTRUMENT PANEL SAFETY PAD: REMOVAL+

17. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH

HINT:

Use the same procedure as for the LH side.

18. REMOVE REAR DOOR SCUFF PLATE RH

HINT:

Use the same procedure as for the LH side.

19. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH

HINT:

Use the same procedure as for the LH side.

20. REMOVE LOWER CENTER PILLAR GARNISH RH

HINT:

Use the same procedure as for the LH side.

21. REMOVE ACCELERATOR PEDAL

Click here 2018 MY Camry [03/2017 - 06/2017]; A25A-FKS (ENGINE CONTROL): ACCELERATOR PEDAL: REMOVAL

22. REMOVE FRONT FLOOR CAUTION PLATE COVER

Click here 2018 MY Camry [03/2017 - 06/2017]; HEATING / AIR CONDITIONING: AIR CONDITIONING UNIT: REMOVAL+

23. DISCONNECT FRONT FLOOR CARPET ASSEMBLY

Click here 2018 MY Camry [03/2017 - 06/2017]; PARKING BRAKE: PARKING BRAKE CABLE (for Front Side): REMOVAL+

24. REMOVE NO. 1 CONSOLE BOX DUCT (for Dual Type)

Click here 2018 MY Camry [03/2017 - 06/2017]; PARKING BRAKE: PARKING BRAKE CABLE (for Front Side): REMOVAL+

25. SEPARATE NO. 1 PARKING BRAKE CABLE ASSEMBLY

Click here 2018 MY Camry [03/2017 - 06/2017]; PARKING BRAKE: PARKING BRAKE CABLE (for Front Side): REMOVAL+

26. REMOVE NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY

(a) Separate the No. 3 parking brake cable assembly from the parking brake equalizer.

*1

Parking Brake Equalizer

*2

No. 2 Parking Brake Cable Assembly

*3

No. 3 Parking Brake Cable Assembly

*4

No. 1 Parking Brake Pull Rod Sub-assembly

(b) Separate the No. 2 parking brake cable assembly to remove the parking brake equalizer.

(c) Slide the parking brake equalizer and rubber boot.

*1

Rubber Boot

*2

Parking Brake Equalizer

*3

No. 1 Parking Brake Pull Rod Sub-assembly

(d) Remove the No. 1 parking brake pull rod sub-assembly from the parking brake equalizer.

27. REMOVE NO. 2 FLOOR UNDER COVER (for LH Side)

Click here 2018 MY Camry [03/2017 - 06/2017]; REAR SUSPENSION: REAR STABILIZER BAR (for 2WD): REMOVAL+

28. REMOVE NO. 1 FLOOR UNDER COVER (for RH Side)

Click here 2018 MY Camry [03/2017 - 06/2017]; REAR SUSPENSION: REAR STABILIZER BAR (for 2WD): REMOVAL+

29. REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

Click here 2018 MY Camry [03/2017 - 06/2017]; A25A-FKS (INTAKE / EXHAUST): EXHAUST PIPE: REMOVAL

30. REMOVE FRONT LOWER NO. 1 FLOOR HEAT INSULATOR

(a) Remove the 2 nuts and front lower No. 1 floor heat insulator from the vehicle body.

31. REMOVE PARKING BRAKE SHOE LEVER

Click here 2018 - 2024 MY Camry [03/2017 -        ]; PARKING BRAKE: PARKING BRAKE ASSEMBLY: DISASSEMBLY

32. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY

(a) Remove the bolt and separate the No. 3 parking brake cable assembly from the backing plate.

33. REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY

(a) Remove the 3 bolts and nut, disengage the clamp and remove the No. 3 parking brake cable assembly.

*1

No. 1 Parking Brake Cable Clamp

-

-

34. REMOVE NO. 1 PARKING BRAKE CABLE CLAMP

(a) Disengage the 2 claws to remove the No. 1 parking brake cable clamp from the No. 3 parking brake cable assembly.