SEAT: FRONT SEAT ASSEMBLY (for TMC Made Power Seat): INSTALLATION; 2018 - 2019 MY Camry [03/2017

Last Modified: 11-20-2023	6.11:8.1.0	Doc ID: RM1000000012TVE
Model Year Start: 2018	Model: Camry	Prod Date Range: [03/2017 - 09/2019]
Title: SEAT: FRONT SEAT ASSEMBLY (for TMC Made Power Seat): INSTALLATION; 2018 - 2019 MY Camry [03/2017 - 09/2019]

INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Be sure to read Precaution thoroughly before servicing.
Click here
Wear protective gloves. Sharp areas on the parts may injure your hands.

PROCEDURE

1. INSTALL FRONT SEAT ASSEMBLY LH

(a) Place the front seat assembly LH in the cabin.

NOTICE:

Be careful not to damage the vehicle body.

(b) Connect the front seat airbag assembly LH connector under the front seat assembly LH.

(1) Before connecting the connector, check that the position of the housing lock is correct as shown in the illustration.

*a	Correct	*b	Incorrect
*c	Yellow CPA	-	-

(2) Be sure to engage the connectors until they are locked (when locking, make sure that a click sound can be heard).

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.

When engaged, the white housing lock will slide. Be sure not to hold the white housing lock and upper part of the yellow CPA, as it may result in an insecure fit.

(d) Connect the cable to the negative (-) battery terminal.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

(e) Temporarily install the front seat assembly LH with the 4 bolts.

(f) Operate the slide and vertical power seat switch knob and move the front seat assembly LH to the rearmost position.

(g) Using a T50 "TORX" socket wrench, tighten the 2 bolts on the front side of the front seat assembly LH.

Torque:

37 N·m {377 kgf·cm, 27 ft·lbf}

NOTICE:

Tighten the bolts in the order shown in the illustration.

(h) Operate the slide and vertical power seat switch knob and move the front seat assembly LH to the foremost position.

(i) Using a T50 "TORX" socket wrench, tighten the 2 bolts on the rear side of the front seat assembly LH.

Torque:

37 N·m {377 kgf·cm, 27 ft·lbf}

NOTICE:

Tighten the bolts in the order shown in the illustration.

2. INSTALL REAR INNER SEAT TRACK BRACKET COVER LH

(a) Engage the 2 claws and guide to install the rear inner seat track bracket cover LH.

3. INSTALL REAR OUTER SEAT TRACK BRACKET COVER LH

(a) Engage the 2 claws and guide to install the rear outer seat track bracket cover LH.

4. INSTALL FRONT INNER SEAT TRACK BRACKET COVER LH

(a) Operate the slide and vertical power seat switch knob and move the front seat assembly LH to the rearmost position.

(b) Engage the 2 claws to install the front inner seat track bracket cover LH.

5. INSTALL FRONT OUTER SEAT TRACK BRACKET COVER LH

(a) Engage the 2 claws to install the front outer seat track bracket cover LH.

6. INSTALL FRONT SEAT HEADREST ASSEMBLY

(a) Install the front seat headrest assembly to the front seat assembly LH.

7. INSPECT FRONT SEAT ASSEMBLY LH

Click here

8. PERFORM DIAGNOSTIC SYSTEM CHECK

Click here