| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM1000000012TLK |
| Model Year Start: 2018 | Model: Camry | Prod Date Range: [03/2017 - 06/2017] |
| Title: EXTERIOR PANELS / TRIM: REAR BUMPER: REMOVAL; 2018 MY Camry [03/2017 - 06/2017] | ||
REMOVAL
CAUTION / NOTICE / HINT
HINT:
If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor system may not operate correctly, so visually inspect the blind spot monitor sensor installation area (frame, stud bolt) to make sure it is not dented or bent.
Click here
![2018 MY Camry [03/2017 - 06/2017]; PARK ASSIST / MONITORING: BLIND SPOT MONITOR SYSTEM: OPERATION CHECK](/t3Portal/stylegraphics/info.gif)
If the visual inspection finds a problem, check the installation condition of the blind spot monitor sensor, and adjust the installation position of the blind spot monitor sensor as necessary.
PROCEDURE
1. REMOVE REAR COMBINATION LIGHT COVER LH
Click here
2. REMOVE REAR COMBINATION LIGHT COVER RH
HINT:
Use the same procedure as for the LH side.
3. REMOVE REAR BUMPER ASSEMBLY
(a) Apply protective tape around the rear bumper assembly as shown in the illustration.
|
Protective Tape |
|
(b) Remove the 2 screws. |
|
|
(c) Remove the clip. HINT: Use the same procedure for the RH side and LH side. |
|
|
(d) for Single Type: (1) Remove the 9 clips. |
|
|
(e) for Dual Type: (1) Remove the 8 clips. |
|
(f) Disengage the 6 claws as shown in the illustration.
|
Remove in this Direction |
HINT:
Use the same procedure for the RH side and LH side.
(g) Disengage the 4 claws and 2 guides to remove the rear bumper assembly as shown in the illustration.
|
|
Remove in this Direction |
|
|