Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM1000000012TLF
Model Year Start: 2018 Model: Camry Prod Date Range: [03/2017 - 06/2017]
Title: EXTERIOR PANELS / TRIM: FRONT BUMPER: REMOVAL; 2018 MY Camry [03/2017 - 06/2017]

REMOVAL

CAUTION / NOTICE / HINT

HINT:

When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.

Click here 2018 MY Camry [03/2017 - 06/2017]; CRUISE CONTROL: MILLIMETER WAVE RADAR SENSOR: ADJUSTMENT

PROCEDURE

1. REMOVE COOL AIR INTAKE DUCT SEAL

(a) Remove the 5 clips.

(b) Disengage the guide and remove the cool air intake duct seal as shown in the illustration.

Remove in this Direction (1)

Remove in this Direction (2)

2. REMOVE FRONT BUMPER ASSEMBLY

(a) Apply protective tape around the front bumper assembly as shown in the illustration.

Protective Tape

(b) Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws as shown in the illustration.

*a

Protective Tape

Insert Screwdriver Here

Remove in this Direction

HINT:

Use the same procedure for the RH side and LH side.

(c) Remove the clip.

HINT:

Use the same procedure for the RH side and LH side.

(d) Remove the 8 screws.

(e) Disengage the 3 claws as shown in the illustration.

Place Hand Here

Remove in this Direction

HINT:

Use the same procedure for the RH side and LH side.

(f) w/ Pre-collision System:

(1) Disconnect the connector.

(g) Remove the 2 clips.

(h) Remove the 4 bolts.

(i) Disengage the 2 claws and 2 guides to remove the front bumper assembly as shown in the illustration.

Remove in this Direction