| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM1000000012TLD |
| Model Year Start: 2018 | Model: Camry | Prod Date Range: [03/2017 - 06/2017] |
| Title: EXTERIOR PANELS / TRIM: FRONT BUMPER: INSTALLATION; 2018 MY Camry [03/2017 - 06/2017] | ||
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.
Click here
![2018 MY Camry [03/2017 - 06/2017]; CRUISE CONTROL: MILLIMETER WAVE RADAR SENSOR: ADJUSTMENT](/t3Portal/stylegraphics/info.gif)
PROCEDURE
1. INSTALL FRONT BUMPER ASSEMBLY
(a) Move the front bumper assembly into position and engage the 2 guides and 2 claws as shown in the illustration.
|
Install in this Direction |
(b) Install the 4 bolts.
Torque:
7.5 N·m {76 kgf·cm, 66 in·lbf}
(c) Install the 2 clips.
(d) w/ Pre-collision System:
(1) Connect the connector.
(e) Engage the 3 claws as shown in the illustration.
HINT:
Use the same procedure for the RH side and LH side.
|
|
Install in this Direction |
(f) Install the 8 screws.
(g) Install the clip.
HINT:
Use the same procedure for the RH side and LH side.
(h) Engage the 4 claws to install the 2 pin hold clips as shown in the illustration.
|
|
Install in this Direction |
HINT:
Use the same procedure for the RH side and LH side.
(i) Install the front bumper assembly.
2. INSTALL COOL AIR INTAKE DUCT SEAL
(a) Engage the guide as shown in the illustration.
|
|
Install in this Direction (1) |
|
Install in this Direction (2) |
(b) Install the cool air intake duct seal with the 5 clips.
|
|