Last Modified: 11-20-2023 |
6.11:8.1.0 |
Doc ID: RM1000000012TIR |
Model Year Start: 2018 |
Model: Camry |
Prod Date Range: [03/2017 - 06/2017] |
Title: AUDIO / VIDEO: ROOF ANTENNA: REMOVAL; 2018 MY Camry [03/2017 - 06/2017] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during roof antenna assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Disconnect cable from negative battery terminal
|
Perform steering sensor zero point calibration.
|
Lane departure alert system (w/ Steering Control)
|
|
Pre-collision system
|
Memorize steering angle neutral point
|
Parking assist monitor system
|
|
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here
PROCEDURE
1. REMOVE ROOF HEADLINING ASSEMBLY
Click here
2. REMOVE ROOF ANTENNA ASSEMBLY WITH COVER
(a) Disconnect the connector.
|
|
(c) Pull the washer and holder as shown in the illustration and remove the roof antenna assembly with cover.
|
Remove in this Direction
|
3. REMOVE ROOF ANTENNA ASSEMBLY
(a) Pull the roof antenna assembly in the direction indicated by the arrow (1) shown in the illustration to disengage the 3 claws and 2 guides.
|
Remove in this Direction (1)
|
|
Remove in this Direction (2)
|
(b) Pull the roof antenna assembly in the direction indicated by the arrow (2) shown in the illustration to disengage the guide and remove the roof antenna assembly.
(c) When reusing the roof antenna assembly:
|