LIGHTING (EXT): HAZARD WARNING SWITCH: REMOVAL; 2018 MY Camry [03/2017

Last Modified: 11-20-2023	6.11:8.1.0	Doc ID: RM1000000012T95
Model Year Start: 2018	Model: Camry	Prod Date Range: [03/2017 - 06/2017]
Title: LIGHTING (EXT): HAZARD WARNING SWITCH: REMOVAL; 2018 MY Camry [03/2017 - 06/2017]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during hazard warning signal switch assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed
Disconnect cable from negative battery terminal	Perform steering sensor zero point calibration	Lane departure alert system (w/ Steering Control)
	Perform steering sensor zero point calibration	Pre-collision system
	Memorize steering angle neutral point	Parking assist monitor system

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

PROCEDURE

1. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Click here

2. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT

Click here

3. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT

Click here

4. REMOVE DEFROSTER NOZZLE ASSEMBLY

Click here

5. REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY

Click here

6. REMOVE NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY

Click here

7. REMOVE NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY

Click here

8. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

Click here

9. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY

(a) Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the hazard warning signal switch assembly as shown in the illustration.

*a	Protective Tape
	Remove in this Direction