Last Modified: 11-20-2023 |
6.11:8.1.0 |
Doc ID: RM1000000012T5T |
Model Year Start: 2018 |
Model: Camry |
Prod Date Range: [03/2017 - 06/2017] |
Title: LIGHTING (INT): REAR DOOR COURTESY SWITCH: REMOVAL; 2018 MY Camry [03/2017 - 06/2017] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear door courtesy light switch assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedures
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Disconnect cable from negative battery terminal
|
Perform steering sensor zero point calibration
|
Lane departure alert system (w/ Steering Control)
|
|
Pre-collision system
|
Memorize steering angle neutral point
|
Parking assist monitor system
|
|
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here
HINT:
-
Use the same procedure for the RH side and LH side.
-
The following procedure is for the LH side.
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click here
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click here
CAUTION:
-
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
-
If an airbag deploys for any reason, it may cause a serious injury.
3. DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
Click here
4. REMOVE REAR SEAT CUSHION ASSEMBLY
Click here
5. REMOVE REAR SEAT CUSHION LOCK HOOK
Click here
6. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
Click here
7. REMOVE REAR SIDE SEATBACK ASSEMBLY
Click here
8. REMOVE REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY
(a) Using a T30 "TORX" socket wrench, remove the screw.
|
|
(b) Disconnect the connector to remove the rear door courtesy light switch assembly.
|