Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM1000000012SQQ
Model Year Start: 2018 Model: Camry Prod Date Range: [03/2017 - 06/2017]
Title: SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: REMOVAL; 2018 MY Camry [03/2017 - 06/2017]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during airbag sensor assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

Replacement of the airbag sensor assembly

Perform system variant learning and acceleration sensor zero point calibration.

  • VSC disabled or malfunctioning
  • DTCs are output
  • Slip indicator light illuminated
  • ABS warning light illuminated

2018 MY Camry [03/2017 - 06/2017]; BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: CALIBRATION

Removal/installation of the front passenger seat

Zero point calibration (Occupant classification system)

  • Occupant classification system
  • Passenger airbag ON/OFF indicator
  • Airbag system (Front passenger side)
  • Seat belt warning system (Front passenger)

2018 MY Camry [03/2017 - 06/2017]; SUPPLEMENTAL RESTRAINT SYSTEMS: OCCUPANT CLASSIFICATION SYSTEM: INITIALIZATION

Disconnect cable from negative battery terminal

Perform steering sensor zero point calibration

Lane departure alert system (w/ Steering Control)

2018 - 2020 MY Camry [03/2017 - 10/2020]; PRE-COLLISION: PRE-COLLISION SYSTEM: INITIALIZATION

Pre-collision system

Memorize steering angle neutral point

Parking assist monitor system

2018 - 2024 MY Camry [03/2017 -        ]; PARK ASSIST / MONITORING: PARKING ASSIST MONITOR SYSTEM: INITIALIZATION

PROCEDURE

1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click here 2018 MY Camry [03/2017 - 06/2017]; SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here 2018 MY Camry [03/2017 - 06/2017]; INTRODUCTION: REPAIR INSTRUCTION: PRECAUTION

2. REMOVE FRONT SEAT ASSEMBLY LH

Click here 2018 - 2019 MY Camry [03/2017 - 09/2019]; SEAT: FRONT SEAT ASSEMBLY (for TMC Made Power Seat): REMOVAL

3. REMOVE FRONT SEAT ASSEMBLY RH

Click here 2018 - 2019 MY Camry [03/2017 - 09/2019]; SEAT: FRONT SEAT ASSEMBLY (for TMC Made Manual Seat): REMOVAL

4. REMOVE CONSOLE BOX ASSEMBLY

Click here 2018 MY Camry [03/2017 - 06/2017]; INTERIOR PANELS / TRIM: FRONT CONSOLE BOX: REMOVAL

5. DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY

Click here 2018 MY Camry [03/2017 - 06/2017]; SEAT: REAR SEAT ASSEMBLY (for Fold Down Seat Type): REMOVAL+

6. REMOVE REAR SEAT CUSHION ASSEMBLY

Click here 2018 MY Camry [03/2017 - 06/2017]; SEAT: REAR SEAT ASSEMBLY (for Fold Down Seat Type): REMOVAL+

7. REMOVE REAR SEAT CUSHION LOCK HOOK

Click here 2018 MY Camry [03/2017 - 06/2017]; SEAT: REAR SEAT ASSEMBLY (for Fold Down Seat Type): REMOVAL+

8. REMOVE FRONT DOOR SCUFF PLATE LH

Click here 2018 MY Camry [03/2017 - 06/2017]; INTERIOR PANELS / TRIM: ROOF HEADLINING: REMOVAL+

9. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH

Click here 2018 MY Camry [03/2017 - 06/2017]; INTERIOR PANELS / TRIM: ROOF HEADLINING: REMOVAL+

10. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH

HINT:

Disconnect the front door opening trim weatherstrip LH to the extent that allows the removal of the lower center pillar garnish LH.

11. REMOVE REAR DOOR SCUFF PLATE LH

Click here 2018 MY Camry [03/2017 - 06/2017]; INTERIOR PANELS / TRIM: ROOF HEADLINING: REMOVAL+

12. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH

HINT:

Disconnect the rear door opening trim weatherstrip LH to the extent that allows the removal of the lower center pillar garnish LH.

13. REMOVE LOWER CENTER PILLAR GARNISH LH

Click here 2018 MY Camry [03/2017 - 06/2017]; INTERIOR PANELS / TRIM: ROOF HEADLINING: REMOVAL+

14. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Click here 2018 MY Camry [03/2017 - 06/2017]; INTERIOR PANELS / TRIM: INSTRUMENT PANEL SAFETY PAD: REMOVAL+

15. REMOVE FRONT DOOR SCUFF PLATE RH

HINT:

Use the same procedure as for the LH side.

Click here 2018 MY Camry [03/2017 - 06/2017]; INTERIOR PANELS / TRIM: ROOF HEADLINING: REMOVAL+

16. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

Click here 2018 MY Camry [03/2017 - 06/2017]; INTERIOR PANELS / TRIM: ROOF HEADLINING: REMOVAL+

17. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH

HINT:

Disconnect the front door opening trim weatherstrip RH to the extent that allows the removal of the lower center pillar garnish RH.

18. REMOVE REAR DOOR SCUFF PLATE RH

HINT:

Use the same procedure as for the LH side.

Click here 2018 MY Camry [03/2017 - 06/2017]; INTERIOR PANELS / TRIM: ROOF HEADLINING: REMOVAL+

19. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH

HINT:

Disconnect the rear door opening trim weatherstrip RH to the extent that allows the removal of the lower center pillar garnish RH.

20. REMOVE LOWER CENTER PILLAR GARNISH RH

HINT:

Use the same procedure as for the LH side.

Click here 2018 MY Camry [03/2017 - 06/2017]; INTERIOR PANELS / TRIM: ROOF HEADLINING: REMOVAL+

21. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Click here 2018 MY Camry [03/2017 - 06/2017]; INTERIOR PANELS / TRIM: INSTRUMENT PANEL SAFETY PAD: REMOVAL+

22. REMOVE ACCELERATOR PEDAL PAD

Click here 2018 MY Camry [03/2017 - 06/2017]; A25A-FKS (ENGINE CONTROL): ACCELERATOR PEDAL: REMOVAL+

23. REMOVE ACCELERATOR PEDAL

Click here 2018 MY Camry [03/2017 - 06/2017]; A25A-FKS (ENGINE CONTROL): ACCELERATOR PEDAL: REMOVAL+

24. REMOVE FRONT FLOOR CAUTION PLATE COVER

Click here 2018 MY Camry [03/2017 - 06/2017]; HEATING / AIR CONDITIONING: AIR CONDITIONING UNIT: REMOVAL+

25. DISCONNECT FRONT FLOOR CARPET ASSEMBLY

Click here 2018 MY Camry [03/2017 - 06/2017]; PARKING BRAKE: PARKING BRAKE CABLE (for Front Side): REMOVAL+

26. REMOVE NO. 1 CONSOLE BOX DUCT (for Dual Type)

Click here 2018 MY Camry [03/2017 - 06/2017]; PARKING BRAKE: PARKING BRAKE CABLE (for Front Side): REMOVAL+

27. REMOVE AIRBAG SENSOR ASSEMBLY

(a) Check that the ignition switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Push down the part (A) in the direction indicated by the arrow (1) to release the lock, and then move the lock lever in the direction indicated by the arrow (2) shown in the illustration to disconnect the connectors.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.

*a

Lock Lever

Release the lock (1)

Disconnect the connector (2)

(d) Remove the 3 bolts and airbag sensor assembly.