Open or short in stop light switch circuit
|
Cruise Control Malfunction Visit Your Dealer
|
Illuminates
|
Sounds
|
Dynamic radar cruise control system is turned off and back on again using the cruise control main switch.
|
Malfunction in SFI system
|
-
|
Illuminates
|
-
|
Dynamic radar cruise control system is turned off and back on again using the cruise control main switch.
|
If either of the following conditions occurs, the ECM cancels control of vehicle speed by the dynamic radar cruise control system (stored vehicle speed is maintained):
-
Vehicle speed is less than approximately 40 km/h (25 mph) while driving with the dynamic radar cruise control system controlling vehicle speed
|
-
|
Does not illuminate
|
Sounds twice
|
+RES switch is pushed.
|
-
Malfunction in the millimeter wave radar sensor assembly
-
Beam axis of millimeter wave radar sensor assembly misaligned
-
Problem with stop light switch input circuit
-
Problem with cruise control main switch cancel circuit
|
Cruise Control Malfunction Visit Your Dealer
|
Illuminates
|
Sounds
|
Ignition switch is turned off and back to ON again.
|
If the following condition occurs, the ECM cancels control of vehicle speed by the dynamic radar cruise control system (stored vehicle speed is maintained):
-
Millimeter wave radar sensor assembly becomes dirty
|
Radar Cruise Control Unavailable Clean Sensor
|
Illuminates
|
Sounds
|
The condition returns to normal (the resume function can be operated after fail-safe is deactivated).
|
If any of the conditions listed below occurs, the ECM cancels control of vehicle speed by the dynamic radar cruise control system (stored vehicle speed is maintained):
-
Millimeter wave radar sensor assembly sensitivity reduced because of bad weather such as rain, fog, snow, or sandstorm
-
Brake control by the dynamic radar cruise control system is temporarily unavailable
-
The beam axis of the millimeter wave radar sensor assembly is being aligned
-
The forward recognition camera is temporarily unavailable
-
A system check is being performed after the engine has started
|
Radar Cruise Control Unavailable
|
Illuminates
|
Sounds
|
The conditions return to normal (the resume function can be operated after fail-safe is deactivated).
|
-
Vehicle stability control system operates while driving with cruise control system controlling vehicle speed
-
TRAC system operates for a certain period of time while driving with cruise control system controlling vehicle speed.
-
TRAC is turned off
-
VSC is turned off
-
Drive start control is performed
|
-
|
Does not illuminate
|
-
|
+RES switch is pushed.
|