| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM1000000012SFE |
| Model Year Start: 2018 | Model: Camry | Prod Date Range: [03/2017 - ] |
| Title: PARKING BRAKE: PARKING BRAKE ASSEMBLY: DISASSEMBLY; 2018 - 2024 MY Camry [03/2017 - ] | ||
DISASSEMBLY
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the LH side and RH side.
- The following procedure is for the LH side.
PROCEDURE
1. REMOVE REAR WHEEL
Click here
![2018 MY Camry [03/2017 - 06/2017]; MAINTENANCE: TIRE AND WHEEL: REMOVAL+](/t3Portal/stylegraphics/info.gif)
2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
Click here
3. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG
Click here
4. REMOVE REAR DISC
Click here
5. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Front Side)
|
(a) Remove the parking brake shoe return tension spring. |
|
6. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Rear Side)
|
(a) Remove the parking brake shoe return tension spring. |
|
7. REMOVE PARKING BRAKE SHOE STRUT
|
(a) Pull the No. 1 parking brake shoe assembly towards the front of the vehicle by hand as shown in the illustration. |
|
|
(b) Remove the parking brake shoe strut. |
|
8. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Lower Side)
|
(a) Remove the parking brake shoe return tension spring. |
|
9. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET
|
(a) Pull the No. 1 parking brake shoe assembly towards the front of the vehicle by hand as shown in the illustration. |
|
|
(b) Remove the parking brake shoe adjusting screw set. |
|
10. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY (for Front Side)
|
(a) Using SST, remove the parking brake shoe hold down spring and No. 1 parking brake shoe assembly. SST: 09718-00011 |
|
11. REMOVE PARKING BRAKE SHOE HOLD DOWN SPRING PIN (for Front Side)
|
(a) Remove the parking brake shoe hold down spring pin. |
|
12. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY (for Rear Side)
|
(a) Using SST, remove the parking brake shoe hold down spring and No. 1 parking brake shoe assembly. SST: 09718-00011 |
|
13. REMOVE PARKING BRAKE SHOE LEVER
|
(a) Using needle-nose pliers, remove the parking brake shoe lever from the No. 3 parking brake cable assembly. |
|
14. REMOVE PARKING BRAKE SHOE HOLD DOWN SPRING PIN (for Rear Side)
(a) Disconnect the skid control sensor wire.
Click here
|
(b) Remove the 4 bolts and rear axle hub and bearing assembly from the rear axle carrier sub-assembly. |
|
|
(c) Remove the nut and separate the backing plate from the rear axle carrier sub-assembly. NOTICE: Use wire or an equivalent tool to keep the backing plate from hanging by the No. 3 parking brake cable assembly. |
|
|
(d) Remove the parking brake shoe hold down spring pin from the backing plate. |
|
|
|