AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM: B15C0,B15C1; GPS Antenna Connection Malfunction(short); 2018 MY Camry [03/2017

Last Modified: 11-20-2023	6.11:8.1.0	Doc ID: RM1000000012S9V
Model Year Start: 2018	Model: Camry	Prod Date Range: [03/2017 - 06/2017]
Title: AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM: B15C0,B15C1; GPS Antenna Connection Malfunction(short); 2018 MY Camry [03/2017 - 06/2017]

DTC

B15C0

GPS Antenna Connection Malfunction(short)

DTC

B15C1

GPS Antenna Connection Malfunction(break)

DESCRIPTION

These DTCs are stored when a malfunction occurs in the telephone and GPS antenna assembly.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area
B15C0	GPS Antenna Connection Malfunction(short)	Telephone and GPS antenna malfunction	Telephone and GPS Antenna Assembly Telephone and GPS Antenna cord Radio and display receiver assembly
B15C1	GPS Antenna Connection Malfunction(break)	Telephone and GPS antenna power source malfunction	Telephone and GPS Antenna Assembly Telephone and GPS Antenna cord Radio and display receiver assembly

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
- A communication malfunction DTC may be stored.
- The radio and display receiver assembly may not operate normally.
Check that the telephone and GPS antenna assembly cable is properly installed and does not have any sharp bends, pinching or loose connections before performing following procedure.
Click here

CHECK DTC

(a) Clear the DTCs.

(b) Recheck for DTCs and check that no DTCs are output.

OK:

No DTCs are output.

2.	INSPECT TELEPHONE AND GPS ANTENNA CORD

(a) Remove the telephone and GPS antenna cord.

Click here

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

*a	Component without harness connected (Telephone and GPS Antenna cord)

3.	INSPECT TELEPHONE AND GPS ANTENNA ASSEMBLY

(a) Remove the telephone and GPS antenna assembly.

Click here

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
3 - 3a	Always	50 to 500 Ω

*a	Component without harness connected (Telephone and GPS Antenna Assembly)