Last Modified: 04-05-2023 |
6.11:8.1.0 |
Doc ID: RM1000000019ZQC |
Model Year Start: 2018 |
Model: Sienna |
Prod Date Range: [11/2017 -
] |
Title: PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SWITCH: INSPECTION; 2018 - 2020 MY Sienna [11/2017 - ] |
INSPECTION
PROCEDURE
1. INSPECT PATTERN SELECT SWITCH ASSEMBLY (PANORAMIC VIEW MONITOR SWITCH)
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Switch Condition
|
Specified Condition
|
8 (D) - 5(E)
|
Pattern Select Switch Assembly (Panoramic View Monitor Switch) pushed in
|
Below 1 Ω
|
8 (D) - 5 (E)
|
Pattern Select Switch Assembly (Panoramic View Monitor Switch) not pushed
|
10 kΩ or higher
|
If the result is not as specified, replace the pattern select switch assembly (panoramic view monitor switch).
|
|
*1
|
Pattern Select Switch Assembly (Panoramic View Monitor Switch) Illumination
|
*a
|
Component without harness connected
(Pattern Select Switch Assembly (Panoramic View Monitor Switch))
|
|
|
(b) Check that the pattern select switch assembly (panoramic view monitor switch) illuminates.
(1) Apply battery voltage to the pattern select switch assembly (panoramic view monitor switch) illumination terminals.
OK:
Measurement Condition
|
Specified Condition
|
Battery positive (+) → 7 (ILL+)
Battery negative (-) → 6 (ILL-)
|
Illuminates
|
If the result is not as specified, replace the pattern select switch assembly (panoramic view monitor switch).
|