Last Modified: 04-05-2023 |
6.11:8.1.0 |
Doc ID: RM100000001983N |
Model Year Start: 2018 |
Model: Sienna |
Prod Date Range: [11/2017 -
] |
Title: PARK ASSIST / MONITORING: BLIND SPOT MONITOR SYSTEM: C1AC2; Slave Module Horizontal Axis Misalignment; 2018 - 2020 MY Sienna [11/2017 - ] |
DTC
|
C1AC2
|
Slave Module Horizontal Axis Misalignment
|
DESCRIPTION
This DTC is stored when the angle of the blind spot monitor sensor LH deviates more than the allowable range from the horizontal axis.
HINT:
If a drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor system on, the blind spot monitor system may store this DTC by mistake.
DTC No.
|
DTC Detection Condition
|
Trouble Area
|
C1AC2
|
When the blind spot monitor sensor deviates 5 degrees or more from the horizontal axis when the system is activated.
|
Blind spot monitor sensor LH
|
CAUTION / NOTICE / HINT
PROCEDURE
1.
|
CHECK INSTALLATION CONDITION
|
(a) Check the installation condition of the blind spot monitor sensor LH (See page
).
HINT:
Take the appropriate action in accordance with the result.
NEXT
|
|
|
2.
|
PERFORM BEAM AXIS CONFIRMATION
|
(a) Install the rear bumper (See page
).
(b) Perform Blind Spot Monitor Beam Axis Confirmation using the Techstream (See page
).
OK |
|
END
|
|