| Last Modified: 04-05-2023 | 6.11:8.1.0 | Doc ID: RM100000001900U |
| Model Year Start: 2018 | Model: Sienna | Prod Date Range: [11/2017 - ] |
| Title: NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: Radio Receiver Power Source Circuit; 2018 - 2020 MY Sienna [11/2017 - ] | ||
|
Radio Receiver Power Source Circuit |
DESCRIPTION
This circuit provides power to the radio and display receiver assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
|
1. |
CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - BATTERY AND GROUND) |
|
(a) Disconnect the radio and display receiver assembly connector. |
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
D195-1 (GND1) - Body ground |
Always |
Below 1 Ω |
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
|
Tester Connection |
Switch Condition |
Specified Condition |
|---|---|---|
|
D195-4 (+B1) - Body ground |
Always |
11 to 14 V |
|
D195-15 (ACC1) - Body ground |
Ignition switch ACC |
11 to 14 V |
|
D196-16 (IG) - Body ground |
Ignition switch ON |
11 to 14 V |
| OK |
|
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|