DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a device to the radio and display receiver assembly via this circuit.

WIRING DIAGRAM

Refer to USB Audio System Recognition/Play Error (See page ).

PROCEDURE

(a) Disconnect the D215 radio and display receiver assembly connector.

(b) Disconnect the D213 No. 1 stereo jack adapter assembly connector.

(c) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition D215-2 (SU1-) - D213-9 (UDO-) Always Below 1 Ω D215-3 (SU1+) - D213-10 (UDO+) Always Below 1 Ω D215-5 (USG1) - D213-12 (UJSS) Always Below 1 Ω D215-2 (SU1-) or D213-9 (UDO-) - Body ground Always 10 kΩ or higher D215-3 (SU1+) or D213-10 (UDO+) - Body ground Always 10 kΩ or higher D215-5 (USG1) or D213-12 (UJSS) - Body ground Always 10 kΩ or higher

*a Front view of wire harness connector (to Radio and Display Receiver Assembly) *b Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly)

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (See page )

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR