Last Modified: 04-05-2023 |
6.11:8.1.0 |
Doc ID: RM100000001900A |
Model Year Start: 2018 |
Model: Sienna |
Prod Date Range: [11/2017 -
] |
Title: NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: Display does not Dim when Light Control Switch is Turned ON; 2018 - 2020 MY Sienna [11/2017 - ] |
Display does not Dim when Light Control Switch is Turned ON
|
CAUTION / NOTICE / HINT
NOTICE:
When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
-
A communication malfunction DTC is stored.
-
The radio and display receiver assembly may not operate normally.
PROCEDURE
1.
|
CHECK IMAGE QUALITY SETTING
|
(a) Display the "Display" screen.
(b) Turn the headlight dimmer switch assembly to the tail or head position.
(c) Check if "Day Mode" on the display adjustment screen is on.
OK:
"Day Mode" setting is off
NG |
|
TURN "Day Mode" SETTING OFF
|
OK
|
|
|
2.
|
CHECK VEHICLE SIGNAL (OPERATION CHECK)
|
(a) Enter the "Vehicle Signal Check Mode" screen. [Refer to Check Vehicle Signal in Operation Check (See page
)]
|
|
(b) Check that the display for "TAIL" changes between ON and OFF according to the headlight dimmer switch assembly operation.
HINT:
-
The display is updated once per second. It is normal for the display to lag behind the actual switch operation.
-
Make sure to move the vehicle to a bright area before performing an operation check with the light control switch in the AUTO position.
OK:
Headlight Dimmer Switch Assembly
|
Display
|
Tail or head
|
ON
|
Off
|
OFF
|
NG |
|
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE
(See page
)
|
|