Last Modified: 04-05-2023 6.11:8.1.0 Doc ID: RM1000000019000
Model Year Start: 2018 Model: Sienna Prod Date Range: [11/2017 -           ]
Title: NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: B15C0,B15C1; GPS Antenna Connection Malfunction(short); 2018 - 2020 MY Sienna [11/2017 -        ]

DTC

B15C0

GPS Antenna Connection Malfunction(short)

DTC

B15C1

GPS Antenna Connection Malfunction(break)

DESCRIPTION

These DTCs are stored when a malfunction occurs in the navigation antenna assembly.

DTC Code

DTC Detection Condition

Trouble Area

B15C0

Navigation antenna malfunction

  • Antenna cord sub-assembly (for navigation antenna)
  • Radio and display receiver assembly

B15C1

Navigation antenna power source malfunction

  • Antenna cord sub-assembly (for navigation antenna)
  • Radio and display receiver assembly

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

  • When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occurs:
    • A communication malfunction DTC may be stored.
    • The radio and display receiver assembly may not operate normally.
  • Check that the antenna cord sub-assembly (for Navigation Antenna) is properly installed and does not have any sharp bends, pinching or loose connections before performing following procedure.

    Click here 2018 - 2020 MY Sienna [11/2017 -        ]; INTRODUCTION: HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS: HOW TO PROCEED WITH TROUBLESHOOTING

PROCEDURE

1.

CHECK DTC

(a) Clear the DTCs.

Click here 2018 - 2020 MY Sienna [11/2017 -        ]; NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: DTC CHECK / CLEAR

(b) Recheck for DTCs and check that no DTCs are output.

Click here 2018 - 2020 MY Sienna [11/2017 -        ]; NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: DTC CHECK / CLEAR

OK:

No DTCs are output.

OK

USE SIMULATION METHOD TO CHECK

NG

2.

INSPECT NAVIGATION ANTENNA ASSEMBLY

(a) Remove the antenna cord sub-assembly (for navigation antenna).

Click here 2016 - 2020 MY Sienna [12/2015 -        ]; NAVIGATION / MULTI INFO DISPLAY: NAVIGATION ANTENNA: REMOVAL

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

GP-1 - 1a

Always

50 to 500 Ω

*a

Front view of wire harness connector

(to Navigation ECU)

OK

REPLACE NAVIGATION ECU

NG

REPLACE ANTENNA CORD SUB-ASSEMBLY (FOR NAVIGATION ANTENNA)