Last Modified: 04-05-2023 6.11:8.1.0 Doc ID: RM1000000018ZZZ
Model Year Start: 2018 Model: Sienna Prod Date Range: [11/2017 -           ]
Title: NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: B158F; AV Signal Stoppage (Low Battery Voltage); 2018 - 2020 MY Sienna [11/2017 -        ]

DTC

B158F

AV Signal Stoppage (Low Battery Voltage)

DESCRIPTION

This DTC is stored when a video or audio signal is interrupted due to battery voltage input to the radio and display receiver assembly dropping temporarily.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

B158F

AV Signal Stoppage (Low Battery Voltage)

A video or audio signal is interrupted when the battery voltage drops

  • Radio and display receiver assembly
  • Harness or connector

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

  • When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occurs:
    • A communication malfunction DTC may be stored.
    • The radio and display receiver assembly may not operate normally.
  • Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE

1.

CHECK VEHICLE SIGNAL (OPERATION CHECK)

(a) Enter the "Vehicle Signal Check Mode" screen. [Refer to Check Vehicle Signal in Operation Check (See page 2018 MY Sienna [11/2017 - 08/2018]; NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: SYSTEM DESCRIPTION 2019 - 2020 MY Sienna [08/2018 -        ]; NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: SYSTEM DESCRIPTION )]

(b) Check that the battery voltage.

Standard voltage:

11 to 14 V

HINT:

This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.

NG

GO TO STEP 3

OK

2.

CHECK FOR DTC

(a) Clear the DTCs (See page 2018 - 2020 MY Sienna [11/2017 -        ]; NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: DTC CHECK / CLEAR ).

(b) Check for DTCs (See page 2018 - 2020 MY Sienna [11/2017 -        ]; NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: DTC CHECK / CLEAR ).

OK:

No DTCs are output.

OK

USE SIMULATION METHOD TO CHECK

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

3.

CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY POWER SOURCE)

(a) Disconnect the radio and display receiver assembly connector.

*a

Front view of wire harness connector

(to Radio and Display Receiver Assembly)

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Condition

Specified Condition

D195-4 (+B1) - Body ground

Always

11 to 14 V

OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR