- Local bus communication line
- Combination meter assembly power source circuit
- Combination meter assembly
- Radio and display receiver assembly
- Harness or connector
| Last Modified: 04-05-2023 | 6.11:8.1.0 | Doc ID: RM1000000018ZZW |
| Model Year Start: 2018 | Model: Sienna | Prod Date Range: [11/2017 - ] |
| Title: NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: B1324; Lost Communication with Meter; 2018 - 2020 MY Sienna [11/2017 - ] | ||
|
DTC |
B1324 |
Lost Communication with Meter |
DESCRIPTION
These DTCs are stored when communication between the radio and display receiver assembly and combination meter assembly is not possible.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
B1324 |
CAN reception error |
|
HINT:
The radio and display receiver assembly is the master unit.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
-
When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occurs:
- A communication malfunction DTC may be stored.
- The radio and display receiver assembly may not operate normally.
- Inspect the fuses for circuits related to this system before performing the following procedure.
HINT:
- B1324 will not continue to output when clear DTC is performed even if the malfunction continues.
PROCEDURE
|
1. |
CHECK DTC |
(a) Check for DTCs and check that no DTCs are output.
Click here
![2018 - 2020 MY Sienna [11/2017 - ]; NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: DTC CHECK / CLEAR](/t3Portal/stylegraphics/info.gif)
OK:
No DTCs are output.
| NG |
|
|
|
2. |
CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - COMBINATION METER ASSEMBLY) |
(a) Disconnect the D196 radio and display receiver assembly connector.
(b) Disconnect the D145 combination meter assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
D196-5 (CNH1) - D145-18 (MSCH) |
Always |
Below 1 Ω |
|
D196-6 (CNL1) - D145-19 (MSCL) |
Always |
Below 1 Ω |
|
D196-5 (CNH1) - Body ground |
Always |
10 kΩ or higher |
|
D196-6 (CNL1) - Body ground |
Always |
10 kΩ or higher |
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
3. |
CHECK COMBINATION METER ASSEMBLY |
(a) Replace the combination meter assembly.
Click here
(b) Clear the DTCs.
Click here
(c) Recheck for DTCs and check that no DTCs are output.
Click here
OK:
No DTCs are output.
| OK |
|
END (COMBINATION METER ASSEMBLY IS DEFECTIVE) |
| NG |
|
|
|