| Last Modified: 04-05-2023 | 6.11:8.1.0 | Doc ID: RM1000000018YBE |
| Model Year Start: 2018 | Model: Sienna | Prod Date Range: [11/2017 - ] |
| Title: PRE-COLLISION: PRE-COLLISION SYSTEM: C1A02; Vehicle Information Not Obtained; 2018 - 2020 MY Sienna [11/2017 - ] | ||
|
DTC |
C1A02 |
Vehicle Information Not Obtained |
DESCRIPTION
When a new driving support ECU assembly is installed, it receives vehicle specification information (destination, steering wheel position, etc.) from the main body ECU (multiplex network body ECU) and stores the information.
DTC C1A02 is stored when the driving support ECU assembly receives the vehicle specification information from the main body ECU (multiplex network body ECU) but cannot store it.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
C1A02 |
Vehicle Information Not Obtained |
The vehicle specification information of the main body ECU (multiplex network body ECU) and driving support ECU assembly do not match for 1 second or more while the vehicle is being driven at a speed of 50 km/h (32 mph) or more. |
Driving support ECU assembly |
CAUTION / NOTICE / HINT
NOTICE:
-
w/ Smart Key System:
It is necessary to perform recognition code registration if the main body ECU (multiplex network body ECU) has been replaced.
If the main body ECU (multiplex network body ECU) is replaced, refer to Registration.
Click here
![2017 - 2020 MY Sienna [08/2016 - ]; THEFT DETERRENT / KEYLESS ENTRY: ENGINE IMMOBILISER SYSTEM(w/ Smart Key System): REGISTRATION](/t3Portal/stylegraphics/info.gif)
- When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.
-
The pre-collision system uses the CAN communication system. First, confirm that there are no malfunctions in the CAN communication system. Refer to How to Proceed with Troubleshooting.
Click here
PROCEDURE
|
1. |
CHECK FOR DTCs (PRE-COLLISION SYSTEM) |
(a) Clear the DTCs.
Click here
(b) Perform the following procedure.
HINT:
If the following procedure is not performed, the previously output DTC cannot be detected.
- Drive the vehicle at a speed of 50 km/h (32 mph) or more for 1 second or more.
(c) Check for DTCs.
Click here
|
Result |
Proceed to |
|---|---|
|
DTC C1A02 is not output |
A |
|
DTC C1A02 is output |
B |
| A |
|
| B |
|
|
|